Abstract:High-load axial compressor is the mainstream of current compressor design and development. In order to improve the aerodynamic performance of high-load axial compressor, an active flow control method in which a synthetic jet is applied to the endwall is proposed. Taking the transonic axial compressor NASA Rotor 35 as the research object, using a single factor analysis method, the influence of five different excitation positions, three different excitation frequencies, and three different jet peak velocities on the aerodynamic performance of the compressor was studied in turn, and obtained the influence law of the endwall synthetic jet excitation parameters. The results show that all three parameters have important effects on the performance of the compressor. Among the excitation parameters studied in this paper, there is an optimal excitation position of 25% Ca. When excited at this position, the flow margin of the compressor is expanded the most. On the basis of maintaining the optimal excitation position and the maximum jet peak velocity, the calculation results found that the jet frequency has little effect on the compressor’s near stall flow rate, but has a great impact on the total pressure ratio and efficiency. The pressure ratio and efficiency increase with the increase of the excitation frequency. However, there seems to be a threshold of the excitation frequency. Only when the excitation frequency is greater than the threshold can the total pressure ratio and efficiency be higher than the prototype compressor. The jet peak velocity has the smallest impact on the compressor performance. Based on the optimal excitation position and the excitation frequency exceeding the threshold, even if the jet peak velocity is small, the compressor can obtain a higher flow margin, total pressure ratio, and efficiency than the prototype compressor. As the jet peak velocity increases, the performance of compressor can be further improved.

Control of Unsteady Separated Flows Inside Axial Compressors by Synthetic Jets

Separation Control Using Synthetic Vortex Generator Jets in Axial Compressor Cascade

Flow Control of Annular Compressor Cascade by Synthetic Jets

Separation Control of Axial Compressor Cascade by Fluidic-Based Excitations

Numerical Investigation on Effectiveness of Flow Separation Control in Two-Dimensional High-Load Compressor Cascade by Synthetic Jet

Separation flow control and engineering application of synthetic jets in compressor

Effects of Actuation Parameters on Flow Separation Control in Compressor with Synthetic Jets

Investigation on A Type of Flow Control to Weaken Unsteady Separated Flows by Unsteady Excitation in Axial Flow Compressors

Active Flow Control on A Highly Loaded Compressor Stator Cascade with Synthetic Jets

Numerical simulation of secondary flow control on high-speed compressor cascade with synthetic jets

Numerical Study on End Wall Synthetic Jet to Improve Performance and Stability Margin of a High-speed Subsonic Axial Compressor Rotor

Numerical Investigation of Three-dimensional Separation Control on a High-speed Compressor Stator Vane with Tailored Synthetic Jet

Flow Separation Control on a Highly Loaded Compressor Cascade Using Endwall Synthetic Jets

Investigation of Flow Characteristic in a Highly-Loaded Compressor Cascade with Synthetic Jet

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Flow Separation Control of an Ultra-compact S-shaped Convergent-divergent Nozzle Using the Blowing Method

Influence of Active Flow Control of Synthetic Jet at Suction Surface on the Performance of a Subsonic Axial Compressor Rotor

Flow control by fluidic-based excitations in axial compressor cascade

Experimental study on multi-angle pulsed jet actuators for controlling corner separation flow in a compressor cascade

Corner Separation Control Using Sweeping Jet Actuator in a Compressor Cascade

Parametric Study on Active Flow Control of a Transonic Axial Compressor Rotor Using Endwall Synthetic Jet