Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Experimental Study on Cooperative Control of Unsteady Separated Flow in Axial-Flow Compressors

Investigation on A Type of Flow Control to Weaken Unsteady Separated Flows by Unsteady Excitation in Axial Flow Compressors

Flow control by fluidic-based excitations in axial compressor cascade

Separation Control of Axial Compressor Cascade by Fluidic-Based Excitations

Control of Unsteady Separated Flows Inside Axial Compressors by Synthetic Jets

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

ACTIVE FLOW CONTROL APPLICATIONS WITH ZERO NET MASS FLUX ACTUATOR IN FLOW FIELD OF SUPERSONIC INLET

Flow Computations of Multi-Stages by URANS and Flux Balanced Mixing Models

Investigations of Multi-Stage Turbomachinery Flow Based on Mixing Plane Models and Unsteady Simulations

Unsteady Cooperative Flow Type in the Axial Compressor

Interaction of unsteady separated flow over multi-bodies moving relatively in the same flow field

Compressibility Effects On The Two Generations Of Unsteady Flow Types In Axial Flow Compressors

NUMERICAL ANALYSIS OF CONTROLLING SEPARATION IN AXIAL CASCADES BY EXCITATION OF PERIODICAL INCOMING WAKE

Flow Control of Annular Compressor Cascade by Synthetic Jets

Separation Control Using Synthetic Vortex Generator Jets in Axial Compressor Cascade

Detached-Eddy Simulations for Active Flow Control

Separation flow control and engineering application of synthetic jets in compressor

The control of flow separation by periodic excitation

Numerical investigations on oscillating aspirations controlling separation flows in linear highly loaded compressor cascades

A parametric study on control authority and vorticity transport in a compressor airfoil with plasma actuation at low Reynolds number

Investigation on unsteady characteristics of flow separation in a supercritical carbon dioxide centrifugal compressor