Abstract:In this paper,based on three-dimensional digital image correlation (3D-DIC),combining crack tip location,chain matching and correlation coefficient thresholding algorithm,the full three-dimensional deformation of metal weldment crack tip was measured to analyze the influence of welding on materials fracture behavior.In experiment,adopting the compact tension specimens with prefabricated fatigue cracks and taking Q235 steel as base material,four kinds of specimen were prepared,which have different welded joint distributions:non weld base metal specimen,weld is located at specimen central part,weld deviates from specimen central part 5mm,weld deviates from specimen central part 8mm,respectively.Experimental results show that 3D-DIC can not only obtain the in-plane deformation induced by crack opening,and extract the crack tip opening displacement,but also can measure the local out of plane depression caused by the yielding of crack tip material.Comparing crack tip field of different weldments,it is revealed that the relative position of crack and weld joint has a great influence on fracture mechanics behavior of specimen.When crack is located at the weld seam,the crack tip opening displacement and local depression are most significant,and crack tip deformation in heat affected zone is significantly higher than that of base metal,so the fracture toughness is higher than that of the base metal.With the increase of load,the stress concentration and local damage will occur at the boundary of the weld seam near the crack,which will ultimately affect the failure behavior of the material.Above results demonstrate that 3D-DIC can be applied to analyze the fracture behavior of heterogeneous material.It may provide effective experimental data for study of practical fracture problems and for validation and refinement of fracture mechanics theory.

Computer Aided System for Implant Cracking Test

Development of A Computer Control and Analysis System for Implant Tester

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Development of Portable Ultrasonic Non-Destructive Test System for Viod Content of Carbon-Fiber Reinforced Plastics

Research of Automatic Ultrasonic Test System for Round Bar Flaw

Test System on Thermal Deformation of Headstock in CA6140 Lathe

Development of New Multi-Function System for Testing Linear Shrinkage and Stress and Hot Cracking of Casting Alloy

Cold Crack Implant Test Study of Superhigh Strength Steel 30Crmnsini2a

Study and Evaluate on Ultrasonic Imaging Nondestructive Testing System for Quality of Electrical Contact

Implantable sensing technology for civil engineering structures

Measurement System Of Wafer Bonding Strength Based On Crack-Opening Method

Robot-Assisted Ultrasonic Testing Technology for Complex Revolved Workpiece

STUDY ON DIRECT EVALUATION OF J-INTEGRAL OF SURFACE CRACK IN WELDMENTS

Automatic loading testing system based on LabWindows/CVI for industrial CT

Study on welding crack sensitivity assessment method based on thermal elastic plastic finite element analysis

Surface Inspection System with Thermal Infrared Imaging for Continuous Casting Billet

Crack Detection and Section Quality Optimization of Self-Piercing Riveting

An Automatic Loading System for Rock Core Testing with an Industrial Ct Scanner

Wireless automatic loading test system for industrial CT based on virtual instrument

Experimental investigation on full three-dimensional deformation near crack tip based on digital image correlation

Ultrasonic Imaging Inspection of Superplastic Solid-Phase Welding Joint Quality