Influence of Strength Matchings on the J-Integrai of Welded Jonts With Transverse Cracks
刘金依,薛河,徐尚龙
DOI: https://doi.org/10.3969/j.issn.0254-6094.2002.03.005
2002-01-01
Abstract:Based on the research of the welded joints with transverse cracks,the J integral values of some of strength matchings of weld seams and widths of weld seams under the plane stress condition with various loads were calculated by using finite element software ANSYS. The result shows that strength matchings had hardly influence on J integral in the ranges of linear elasticity and small yield,i.e, P/P 01; the influence of strength matchings on J integral was relative to a/h in elastic plastic range,i.e, P/P 0 1. With the increase of a/h ,the load needed by strength matchings for the composition of J integral became bigger. The weld seam width had an evident influence on J integral when the crack size was very small and P/P 0 0.9; the influence of weld seam width on J integral disappeared when the crack size was bigger than the weld seam width.
What problem does this paper attempt to address?