Abstract:With air-methane premixed gas as medium,a series of experiments were conducted under both constrained and unconstrained conditions of caliber to study the varying characteristics of explosion venting pressure in 22Lspherical container with different dimensionless pressure relief ratios.The results show that,in constrained circumstances and with broken membrane pressure unchanged,both the rising rate of maximum explosion venting pressure and the maximum vented pressure inside the spherical container increase with decrement of dimensionless pressure relief ratio.If the dimensionless pressure relief ratio is more than a certain value,the vented explosion is balanced vented explosion;if not,it is non-balanced vented explosion.Under constrained condition,when dimensionless pressure relief ratio is more than 0.009and less than 0.025,vented explosion has remarkable effect and the pressure decreases obviously.When dimensionless pressure relief ratio is more than 0.00169and less than 0.009,the maximum venting pressure is close to the pressure of hermetic explosion and the pressure does not decrease well.When dimensionless pressure relief ratio is less than 0.00169,the maximum explosion venting pressure slightly exceeds the maximum explosion pressure in closed vessel.Under the unconstrained condition,the maximum explosion venting pressure inside spherical container with different dimensionless pressure relief ratios is lower than the maximum explosion pressure in closed vessel.The results provide scientific basis for the safety design of vented explosion in spherical container in the industrial production.

Rectification of the Pressure Explosion Formula of Low Carbon Steel Pressure Vessels

Explosive Experiment of Mild Steel Pressure Vessel and Research on Formula of Explosive Stress

Research on Bursting Pressure Formula of Mild Steel Pressure Vessel

Research on Plasticity Modification of Strain Relief Coefficients in Q235 Steel

Research on Reasonable Winding Angle of Ribbons of Flat Steel Ribbon Wound Pressure Vessel

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Numerical Investigation on Explosion of Quick Actuating Pressure Vessels Due to Residual Pressure

Study on Methods for the Reinforcement of Pressure Vessels with Large Openings

FAD Method for Explosion Containment Vessels Based on API 579 - 1/ASME FFS - 1

Numerical Simulation of Internal Explosion and Dynamic Response Analysis for Vertical Cylindrical Steel Tanks

Study on Influence of Test Methods for Determining Explosion Limits of Flammable Refrigerants

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Safety analysis of pressure piping containing incomplete penetration under combined loads

Experimental Study of the Lewis Factor of a Flatly and Straightly Finned Tube Heat Exchanger at the Air Side at a Low Atmospheric Pressure

Calculations of Plastic Collapse Load of Pressure Vessel Using FEA

Dynamic Burst Pressure of Cylindrical Explosion Containment Vessels

Change Characteristics of Gas Explosion Venting Pressure Inside Spherical Vessel with a Small Caliber

DISCUSSIONS ON PRACTICAL CALCULATION OF AXIAL AND FLEXURAL LOAD VERSUS DEFORMATION CURVES OF CFST AFTER EXPOSURE TO FIRE

Discussion on Revision of the Elevated Temperature Analysis Scheme in Pressure Vessel Design by Analysis Standard

Numerical and experimental study of the explosions caused by residual pressure in quick actuating vessels

Numerical Investigation of Pressure in Oxy-Fuel Glass Furnace