Abstract:Due to the behavior of low-density and high-energy absorption efficiency, rubber materials are now being extensively applied to solve geotechnical problems. In order to ensure the rational and economical use of rubber sand mixtures in geotechnical engineering, it is necessary to systematically study the compression behavior of rubber sand mixtures, especially under repeated loading–unloading mode. In this study, three series tests, including one-dimensional compression tests and repeated loading–unloading tests, were conducted on rubber sand mixtures with various rubber contents. The development of the void ratio, compression coefficient, elastic strain, and plastic strain of the mixtures under different load modes was investigated. Results showed that compared to pure sand, rubber sand mixtures exhibited different compression deformation behavior. The rubber content had a significant impact on the compression behavior of rubber sand mixtures. The compression behavior of the rubber sand mixture changed from low to high compressibility when the rubber content was greater than 10%. Also, with the increase of rubber content from 0% to 20%, the ratio between elastic and plastic strain of the mixtures increased from 1∶5 to 2∶3. When subjected to loading and unloading cycles within a large stress range (0–1,600 kPa), the rubber sand mixture underwent significant elastic strain, and plastic strain gradually accumulated with the number of cycles. When the repeated loading and unloading test started at a certain initial pressure (800–1,600 kPa), the elastic deformation of the rubber sand mixture decreased to a smaller level and did not change significantly with the number of cycles. At this point, plastic strain mainly occurred in the first cycle, and almost no plastic strain occurred in subsequent cycles. Rubber content below 10% has lower compressibility and is a recommended rubber content (RC) value for use in engineering. In addition, setting a certain initial pressure is an effective method to reduce the elastic strain of mixtures and improve the accumulation of plastic strain in engineering applications.

Load-Compression Relationships of Bonded Rubber Ring

Load-Compression Relationship of Incompressible Circular Rubber Pad Bonded between Rigid Plates

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

Effect of Swelling Behavior of Rubber Rings on the Sealing Performance for 70MPA Hydrogen Pressure Reducing Valves

Research on cohesive failure behavior and parameter sensitivity of rubber – SET under cohesive zone model

A Novel Structure of Rubber Ring for Hydraulic Buffer Seal Based on Numerical Simulation

Research on Key Factors of Sealing Performance of Combined Sealing Ring

Impact and Rebound of an Elastic–plastic Ring on a Rigid Target

Structural Design and Sealing Performance Analysis of Biomimetic Sealing Ring

Novel Ring Compression Test Method to Determine the Stress-Strain Relations and Mechanical Properties of Metallic Materials

The Compression and Friction of Tubular Rubber Seal under the Curved Surface Loading

Stress Analysis and Sealing Capability Research of Rubber Sealing O-Ring for Static Sealing

Investigation of Static and Dynamic Seal Performances of a Rubber O-Ring

Analysis on Sealing Performance for a New Type of Rubber Olecranon-Shaped Sealing Ring in Pipe Jacking Joint

Static and Dynamic Sealing Performance Analysis of Rubber D-Ring Based on FEM

Analysis on the Characteristics of Nonlinear Deformation of Rubber Circular Membrane under Pressure

Experimental Investigation on the Compressive Behavior of Rubber–Sand Mixtures under Repeated Loading–Unloading

A Visco-hyperelastic Constitutive Model for Rubber Considering the Strain Level and One Case Study in the Sealing Packer

The effect of loaded area on constitutive relationship of metal-rubber

Comparison Between Two Solutions Based on the Relationship of Load-deflection Character of a Large Deflection Rubber Circular Plate