Abstract:With the development of unconventional oil and gas resources, the multi-stage fracturing technology with immovable string has been developed rapidly due to its advantages of large construction capacity and multiple fracturing stages. But the failure of packer has become a bottleneck restricting the development of technology. In this paper, the mechanical properties of corroded ((under the environment of I(North Troyes),II(Jeannajor) and III(Khasib)) ) and uncorroded rubber of the packer were tested by designed experiments at first. The experimental values showed that elastic modulus, shear strength and tensile strength decreased when packers were corroded. Then, according to packers' structure and load characteristics, taking the rubber cylinder, rubber support, center pipe, tubing and string as research object, the dynamic model was established for tubes and packers in fracturing layers. Based on conditions of the shear strength, pressure seal and axial movement for rubber cylinder, the safety evaluation method was proposed for packer sealing system. And the failure evaluation of multistage fracturing packer in Gao182-151 well in Daqing Field was carried out by the method established in this paper. At last, we could get the following results: the sealing safety coefficients of upper and lower packers were all greater than 1.0 during the fracturing process of layer I to IV. The axial displacement of the packer's rubber of the non-corrosive and corrosivewere all 0.00. So the packers were sealed well in each stage of fracturing, and no leakage accidents occurred during the entire fracturing process of Gao 182-151 Well. But in the fracturing layer I, the shear safety factor of the corroded (under corrosive environment of I(North Troyes),II(Jeannajor) and III(Khasib)) rubber were is 1.00, 1.10, 0.99 respectively. The shear strength was less than or equal to 1.10 and it didn't not satisfy the shear strength. Therefore, we could get the conclusion that the corroded rubber did not meet the shear strength and rubber tearing was prone to occur in the fracturing layer I. So it is recommended to replace the rubber with a new one before the construction of Gao 182-151Well.

Research on cohesive failure behavior and parameter sensitivity of rubber – SET under cohesive zone model

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Experimental Investigation on the Dynamic Compressive Behavior of Rubberized Concrete

A Visco-hyperelastic Constitutive Model for Rubber Considering the Strain Level and One Case Study in the Sealing Packer

Optimization of Cohesive Parameters in the Interfacial Transition Zone of Rubberized Concrete Based on the Response Surface Method

Nonlinear finite element analysis on the sealing performance of rubber packer for hydraulic fracturing

Adaptability of hydraulic fracturing packers and optimization of their sealing performance for three common clastic rock reservoirs based on finite element analysis

Experimental Investigation on the Compressive Behavior of Rubber–Sand Mixtures under Repeated Loading–Unloading

Mechanical Behavior and Structure Optimization of Compressed PHP Packer Rubber

Failure evaluations for packers in multistage fracturing technology with immobile strings

Experimental Study and Failure Criterion Analysis on Combined Compression-Shear Performance of Rubber Concrete (RC) with Different Rubber Replacement Ratio

Ternary medium constitutive model of frozen rubber-reinforced expansive soil

Investigation on Bond Behavior between Self-compacting Rubberized Concrete and Rectangular Steel Tubes

Interfacial friction effects on sealing performances of elastomer packer

Experimental Investigation on the Compressive Behaviour of Rubber-Sand Mixtures Under Repeated Loading-Unloading

Research on key technology of packer rubber barrel for integrated fracturing and completion of gas well

Solid expandable tubular forming behavior based on twin shear stress yield criterion: Analytical, numerical simulation and experiment

Load-Compression Relationships of Bonded Rubber Ring

Compressive mechanical properties of styrene-butadiene rubber under medium-low strain rates: Experiments and modeling

Investigation on mechanical properties and corrosion behavior of rubber for packer in CO2-H2S gas well

Research on Modeling Improvement of Rubber Isolators by Considering Multi-Loading Conditions