Abstract:The manufacture method based on the silicon etching process is one of the most important methods to fabricate micro mechanical structure, e.g. micro-engine. In the processing, the high aspect ratio silicon etch process (HARSE process) is very important to improve the efficiency of structure. At the same time, the surface morphology should be controlled exactly to keep the performance of structure. In this paper, the feasibilities of controlling the surface morphology and Si etch rates were experimentally investigated. In the experiments, the width of structure changes from 15um to 1500um and the depth changes from 50um to 500um. The parameters of surface morphology including sidewall angle, surface roughness, and so on were measured and compared. The influence mechanisms of etching parameters were analyzed. The etching process were completed in a surface technology system (STS) multiplex advanced silicon etcher inductively coupled plasma (ICP) system with SF6/O2 plasma as etching plasma and C4F8 as passivation plasma. In the experiments, the etching experiments were conducted in a low pressure (5–50mTorr), high density, inductively coupled plasma etching reactor (ICP) with a planar coil. The Si etches rates and sidewall angle were investigated as a function of chamber pressure, cathode RF-power, and gas flow. The results indicated that the increasing of total etching time results in an acceleration in etch rate as well as the decrease in sidewall angle (the top width of trench is narrow than the bottom width). Meanwhile, the total passivation time has an opposite effect in the influence of etch rate and sidewall angle. All the experiments indicate that the quick shift between etch and passivation period leads to a smoother surface. An interesting phenomenon were discovered that the etch rate will not change with the changing of width parameter in most of the high aspect ratio silicon etch recipes when the width-depth ratio is upper than 0.34. An experiential function formula were fitted based on four parameters, including width and depth of the structure, and total etching and passivation time.

Dry Etching Technique for Silicon of High Aspect Ratio in MEMS Device Fabrication

High Aspect Ratio Si Etching Technique and Application

Study on Silicon Deep Wet Etching Technology for MEMS

Fabrication of High Aspect Ratio Structure and Its Releasing for Silicon on Insulator Mems/Moems Device Application

Fabrication of High Aspect Ratio Muti-Steps on Si by Dry Etching

Uniform Metal-Assisted Chemical Etching for Ultra-High-Aspect-Ratio Microstructures on Silicon

The Control Method of Surface Morphology and Etch Rates for Silicon Etch Process with Extremely Deep and High Aspect Ratio

Critical tasks in high aspect ratio silicon dry etching for microelectromechanical systems

High Aspect Ratio Etching of Nanopores in PECVD SiC Through AAO Mask

Experimental Study on Roughness and Flatness of Micromirror Fabricated by Different Anisotropic Silicon Etching Processes

A single-mask dry-release process for fabrication of high aspect ratio SOI MEMS devices

Cryogenic DRIE Processes for High-Precision Silicon Etching in MEMS Applications

Research on Micro Structures of Si Surfaces after Wet Chemical Etching

Imprint Template Fabrication Method for MEMS Based on Wet Etching

Toward Controllable Wet Etching of Monocrystalline Silicon: Roles of Mechanically Driven Defects

Application of ICP Etching Technology in MEMS Field

Research on TMAH Wet Etching in MEMS

Etching mechanism of high-aspect-ratio array structure

An Etching Method for Fabricating Anisotropic Silicon Nanostructures with Vertical and Smooth Sidewalls

Wafer-Scale Fabrication of Ultra-High Aspect Ratio, Microscale Silicon Structures with Smooth Sidewalls Using Metal Assisted Chemical Etching

Application of KOH Anisotropic Etching in the Fabrication of MEMS Devices