Abstract:To meet the high requirements for positioning accuracy and multiple dimensions of positioning systems in the fields of precision measurement and precision machining, a new submicron-precision three-dimensional (3D) low cross-interference positioning system is designed and fabricated in this paper. The 3D motion stage mainly includes a mechanical structure, a support and guide system, and a driving system. The Abbe offset error is eliminated by adopting a coplanar structure in the X and Y directions, thus minimizing the mutual cross-interference of the motion stage. The X and Y motion stages are driven by a ball screw pair and an alternating current servo motor, which are supported and guided by an air-floating rail and slider. Moreover, the X and Y air-floating stages adopt a lateral structure and double rails, respectively. The Z-motion stage is directly driven by a high-precision piezoelectric motor. In addition, the system achieves high-precision motion by using the dual-loop control technology of secondary feedback combined with the high-resolution control characteristics of the servo motor. The performance of the positioning system is evaluated through a series of verification experiments. Results show that the stroke of the positioning system of the 3D air-floating motion stage can reach 100 × 100 × 100 mm3, and the repeated positioning accuracy is better than 0.41 μm (k = 2, k is defined by the International Organization for Standardization as the coverage factor). The maximum cross-interference of the X-stage is 180 nm, and the Y-stage reaches 320 nm when running with a full stroke of 100 mm in the Z-direction, demonstrating good repeatability, stable running, and high straightness. The submicron-precision 3D air-floating motion stage developed in this paper can be used as a suitable solution for coordinate measuring machines, microlithography, and micromachining applications when combined with an additional nanoprecision microstage.

Design of a Subminiature Anti-Particles Load-Supporting Stage for Near-Field Optical Storage

Ultra submicron flying head design for near-field optical storage

Design And Analysis Of Two Dimensional X-Y Micropositioning Stage

Modeling, Design and Analysis of a Micro Flying Slider in Near-Field Optical Storage System

Design and Analysis of a Novel Micro Flying Head in Mass Storage System

Development of real-time method to measure SIL-DISK spacing for super-low-flying system

The Application of Near-Field Optics in High Density Data Storage

Nano-and Micro-Actuations of Hard Disk’s Head Positioning System: Actuator Design and Evaluation of Performance

Design and fabrication of an integrated optical flying head for near-field recording system

Near-field optical recording based on solid immersion lens system

Near-Field Optical Storage System Using A Solid Immersion Lens With A Left-Handed Material Slab

A Novel Piezoelectrically Actuated 2-Dof Compliant Micro/Nano-Positioning Stage with Multi-Level Amplification

Research on the Design and Fabrication of Air Bearing Sliders in Hard Disk Drives

A Novel Monopolar Cross-Scale Nanopositioning Stage Based on Dual Piezoelectric Stick-Slip Driving Principle

Design of a Four-Sided Magnetic Circuit for an Optical Pickup Actuator for Multilayer High-Density Optical Disks

A New Positioning and Loading System for the Study of the Mechanical Behavior of Small and Micro Components

Development of submicron precision three-dimensional low cross-interference air-floating motion stage

Experimental research on near-field optical storage and virtual probe based on solid immersion lens

A Novel Framework of Lightweight Optimization Design of a Prototype Wafer Stage With Control Verification

Design and Experimental Investigation of Three Degrees of Freedom Nanoscale Microsuspension Actuators

Design, Control of an Aerostatic X-Y Planar Motion Stage for Precision Positioning