Abstract:The cooling of working rolls is an important process in the hot rolling technology. The optimal cooling of rolls should be designed with respect to two aspects. The first is the wearing of a roll where high temperature decreases the durability of the surface layer. The second aspect is a thermal deformation of a roll. This is critical for the shape and tolerance of flat products. Cooling at rolling mill should be designed with consideration to both aspects. Finding optimum pressure and flow rate is a difficult task. In regards to water quantity, the experience shows that the phrase “more is better” is not valid here. In other word – an increase in the amount of water can even cause a decrease in cooling intensity. Water nozzles are typically used in this case. There are many of factors which can influence the efficiency of the nozzle cooling system: Type of a nozzle, geometrical configuration (nozzle pitch, distance from the roll, orientation, number of manifolds), coolant pressure and temperature. Cooling intensity is mostly specified through Heat transfer coefficient (HTC) or heat flux (HF) distribution. Coolant flow on the rotating roll surface makes the problem complex. Surface temperature of the cylinder plays an important role in the heat transfer mechanism, especially for higher temperatures where boiling must be considered. No analytical or numerical solution of heat transfer and fluid flow for this case is known. The task can be successfully solved experimentally. An experimental bench and methodology of realistic boundary conditions determination was developed in the Heat Transfer and Fluid Flow Laboratory (HEATLAB). The strategy of optimization is based on two steps. First is investigation of present situation of work roll cooling system and second is design of a new system. Criterion of optimization is saving of cooling water with remaining or increasing of cooling intensity. Comparison of the original design and new design was done numerically, using special software and experimentally by temperature measurement of working roll after specified rolling campaign. Optimized cooling system was applied on hot flat rolling mill in voestalpine Stahl GmbH.

Test Research for the External Cooling Interface Heat Transfer Coefficient of Rollers

Study on the External Cooling Mechanism of Aluminium's High-speed Cast-rolling Process

Study on External cooling system of speed cast-rolling of Aluminium strap

Study on heat transfer and friction characteristics in fin-tube heat exchangers used for electrical machines cooling

Theoretic Analysis and Experiment on Improving Heat Transfer Ability of Cast-Rolling System

Simulation of Heat Transfer Behavior of Shaped Interface in Aluminum Cast-Rolling Process

Experimental Study on Heat Transfer in Rolling Ash Cooler

Research on the Temperature and Thermal Stress of the Roll Quenching Process of Thin Plates

Model experiments for the determination of the heat-transfer coefficient and transition thermal analysis in the direct rolling process

Experimental Study On Thermal Effect Of Tilted Roller Pairs In Rolling/Sliding Contacts

Study on general convective heat transfer criterion correlation for rolling-processed finned bimetal tubes

Numerical Simulation Research on the Temperature Field and Hot Roll Crown Model of Hot Continuous Rolling Mills

Online Partition-Cooling System of Hot-Rolled Electrical Steel for Thermal Roll Profile and Its Industrial Application

Optimization of working roll cooling in hot rolling

Thermal Analysis for Cooling Rolls in Planar-flow Melt Spinning

Experimental study on temperature drop during roller quenching process of large-section ultra-heavy steel plate

Research on Temperature Change Law and Non-Uniform Distribution Characteristics of Electromagnetic Control Roll Based on Rotating Heat Flow

Flow and heat transfer in a novel convex cooling roller with axial variable boundary for planar flow casting

Experimental Study on Heat Transfer Boundary Conditions for Steel Hot Extrusion Process

Optimization of Temperature Distribution in Thick Slab Continuous Casting for Direct Hot Rolling

Effect of Coating of Continuous Casting Crystallization Roller on Heat Transfer and Solidification Structure