Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

Study on External cooling system of speed cast-rolling of Aluminium strap

Study on the External Cooling Mechanism of Aluminium's High-speed Cast-rolling Process

Test Research for the External Cooling Interface Heat Transfer Coefficient of Rollers

Theoretic Analysis and Experiment on Improving Heat Transfer Ability of Cast-Rolling System

Study on Temperature Model and Self-Adaption for Finishing Stands of Hot Strip Mill

Optimization of Temperature Distribution in Thick Slab Continuous Casting for Direct Hot Rolling

Study on Influence of Surface Coating During Cooling Slope Rheocasting Process

Simulation of Heat Transfer Behavior of Shaped Interface in Aluminum Cast-Rolling Process

Comparative study on effects of microstructures of hot rolled and twin roll casting 1235 aluminium alloy on surface quality of aluminium foils produced

Numerical Analysis of the Cooling System Performance and Effectiveness in Aluminum Low-Pressure Die Casting

Numerical Simulation of Cast-rolling Process for Copper-Aluminum Composite Plate

Effect of the rolling speed on the flow field and solidification welding line of the roll casting for AZ31 magnesium alloy

Upgrade Rolling Based on Ultra Fast Cooling Technology for C-Mn Steel

Online Partition-Cooling System of Hot-Rolled Electrical Steel for Thermal Roll Profile and Its Industrial Application

Secondary Cooling Control of Continuous Casting Process with Model Strategy

Effect of cooling route on microstructure and mechanical properties of twin-roll casting low carbon steels with an application of oxide metallurgy technology

Secondary Cooling Design for Slab Caster Based on Transient Heat Transfer Module

Numerical Simulation Research on the Temperature Field and Hot Roll Crown Model of Hot Continuous Rolling Mills

Research on dynamic secondary cooling control model for slab continuous casting machine with high casting speed

Pattern Recognition of Thermal Analysis Cooling Curves and Quality Evaluation of Melt Cast Alloys

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters