Abstract:Journal of Composite Materials, Ahead of Print. In this study, a three-dimensional random representative volume element model was constructed using the finite element method combined with Python script to investigate the residual stress distribution in SiCp/Al composites with varying volume fractions, particle shapes, and particle size under thermal cycling conditions. The model has two different particle morphologies: spheres and irregular polygons. The results show that the irregular polygonal SiC particles exhibit higher residual stresses than spherical particles before and after thermal cycling due to their complex load transfer pathways and higher stress concentration at particle corners, which makes them more consistent with the characterization of SiCp/Al composites under practical application conditions. As the volume fraction of SiC particles increases, the particle spacing decreases, hindering the release of thermal stresses through plastic deformation. Notably, the relief rate of residual stress reached 53% in the 12 vol% SiCp/Al composites, with the stress decreasing from 698 MPa to 328 MPa after 50 thermal cycles. In contrast, the reduction rate for 18 vol% composites is only 13% after thermal cycling. Furthermore, compared to larger particles (7.3 μm, 8.9 μm), the smaller particles (4.3 μm, 5.9 μm) exhibit a more uniform stress distribution and lower thermal stresses before and after thermal cycling. Consequently, our work provides a significant theoretical basis for the design and application of SiCp/Al composites, especially for the application of materials under extreme temperature changes.

Relaxation Behavior of Residual Stress in an Extruded Tube of the SiCw/Al Composite at High Temperature

Forming process of hot-extruded SiCw/6061AI composites(I)

MICROSTRUCTURES AND PROPERTIES OF HOT-EXTRUDED SiCW/6061Al COMPOSITES

Thermal Relaxation of Residual Stresses in Shot Peened Surface Layer of SiCw/Al Composite

Residual stress variation in SiCf/SiC composite during heat treatment and its effects on mechanical behavior

A Study of the Residual Stress and Its Influence on Tensile Behaviors of Fiber-Reinforced Sic/Al Composite

Thermal residual stress in continuous SiC fiber reinforced titanium matrix composites

The performance transition of C/SiC composites induced by redistribution of residual stress

The Effect of Residual Stress on Whisker Reinforcements in SiCw-Al2O3 Composites During Cooling

Study of the residual stress distribution in SiCp/Al composites under thermal cycling conditions

Investigating the Effects and Mechanisms of Thermal–Vibration-Coupled Stress Relief Treatment on Residual Stress in SiC/Al Composites

Influence of Reinforcement with Multimodal Distribution on Thermophysical Properties and Fracture Behavior in Al-Si/SiC Composites Infiltrated under Super-Gravity Field

Evaluation of residual stress relief of aluminum alloy 7050 by using crack compliance method

Low Cycle Fatigue and Creep Fatigue Interaction Behavior of 9Cr-0.5Mo-1.8w-v-nb Heat-Resistant Steel at High Temperature

Compressive creep aging behavior and microstructure evolution in extruded Al-Mg-Si alloy under different temperature and stress levels

Study on thermal deformation behavior and microstructural evolution of 2 wt. % Al–Ti–C/7075Al composite materials

High-temperature tensile behavior of 3D SiC/SiC composites

Residual stress analysis in the Al2O3/Ti 3SiC2 multilayer composites

Damage accumulation during high temperature fatigue of Ti/SiCf metal matrix composites under different stress amplitudes

Effect of thermal residual stress on the tensile properties and damage process of C/SiC composites at high temperatures

Depth profiling and thermal relaxation of residual stress in Al2O3f/SAE321 composites observed by SEAM