Abstract:The device was developed to accurately measure the Concentration of pulverized coal in the pneumatic conveying pipe. The sensor assembly was composed of γ-ray source, tube of the sensor, ionization chamber fill with inert gas electrometer and lead cannon tube shield. The γ point source was fixed at the cross-section centre of the pipe, the collimation exit portal was vertical to the axis line of the conduct, in which the outgoing beam of the γ rays was assumed at the plane 360 degrees; the profile of the ionization chamber was designed ring cross section, independent mult-cavity. The γ-ray from the source penetrated the gas-solid two phase flow and the single tube wall, arrived at the corresponding independent cavity. The inert gas filled in the cavity was ionized by the γ-ray, the ions was collected by the high voltage plates, the ionic stream was converted into direct voltage by the electrometer in the cavity, as the output of the cavity. The concentration of the corresponding sector in the tube could be determined according to the law of γ-ray mutual effect with the matter. The arithmetic mean of the output voltages from the electrometers in the cavities of the ionization chamber was taken as the measured value of volume concentration of the pulverized coal in the tube. The proving trial shows that the input-output character of the sensor assembly was the phase distribution; the measuring accuracy was superior 2%, the γ-ray radioactivity requirement was reduced obviously as only single tube wall was required to be penetrated by γ-ray.

Studies of Pulverized Coal Concentration Measurement in 660MW Boiler Coal Pipe

Experimental Study on On-Line Monitoring Pulverized Coal Fineness of 300 MW Coal-Fired Plant by Digital Holography

RESEARCHES ON THE IGNITION REGULATION OF THE PULVERIZED COAL-AIR FLOW IN A TUBE

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Measurement on the Pulverized Coal Concentration after a Combination of Two Elbows Using Method of Optic Fluctuation Theory

On-line Electromagnetic Wave Based Coal Concentration Monitoring Technique for Pipe Flow

Cold Gas-Particle Flows in a New Swirl Pulverized Coal Burner by PDPA Measurement

Design and Experimental Study on the Pulverized Coal Concentration Sensor Based on Gamma-Ray Absorption Method

Studies of Gas-Solid Two-Phase Flow Diffusion Based on Optical Wave Method

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

Study on the Flame Monitoring and Combustion Diagnosis Control Optimizing Inside Pulverized Coal Boiler of Power Plant

Design and Implementation of A Pulverised Coal Flow Monitoring System for Coal-Fired Power Plant Applications

Measurement of the Mass Flow and Velocity Distributions of Pulverized Fuel in Primary Air Pipes Using Electrostatic Sensing Techniques

EXPERIMENTS OF NUMBER CONCENTRATIONS OF SUBMICRON PARTICULATE MATTERS DURING PULVERIZED COAL COMBUSTION AND THEORETICAL ANALYSIS

Optimization of Venturi Tube Design for Pipeline Pulverized Coal Flow Measurements

An Investigation of New Methods for Attaining an Optimized Operation of Small and Medium-sized Pulverized Coal-fired Boilers

Pulverized coal flow metering on a full-scale power plant using electrostatic sensor arrays

Study on coal combustion characteristics in a W-shaped boiler furnace

CFD Study of a Pulverized Coal Boiler

Study on experiments and numerical simulation of coal combustion characteristics under different thermal environments

Dynamic Monitoring of Flue Gas Composition During Clean Coal Combustion in Industrial Boiler