Numerical simulation and experimental validation of pulverized coal combustion by using CFD
Phariyaphong Sakolaree,Kamolpob Rattanaphaibun,Wiwit Sukhanonsawas,Yanin Sukjai
DOI: https://doi.org/10.1063/5.0099579
2022-08-31
AIP Conference Proceedings
Abstract:Nowadays, the utilization of pulverized coal is limited only in large-scale enterprises in Thailand as the knowledge of pulverized coal burner technology in small-scale burners is not widely known and studied. Therefore, it is important to keep on research and development efforts in order to further propel the pulverized coal technology into widespread use because it has many attractive features such as lower fuel cost, reduced pollution, and better combustion efficiency. The objective of this research is to numerically model and analyze the combustion characteristics of pulverized coal in an axisymmetric 2-D combustion chamber model by using CFD. For experimental validation, this work focuses on the following simulation conditions: coal particle diameter smaller than 74 μm, primary air mass fraction of 25%, secondary air mass fraction of 65%, and tertiary air mass fraction of 10%. The pulverized coal is sprayed into the burner along with the primary air and mixed with the secondary and the tertiary air in the burner due to the effect of the secondary air vortex flow. The governing equations for the turbulent flow analysis in the combustion chamber is the Turbulence Model Standard K-E. For particle motion analysis, including devolatilization and heterogeneous combustion is analyzed by Discrete Particle Model (DPM). Homogeneous combustion is analyzed by using Eddy-Dissipation model. It is assumed that the concentration of the chemical reaction is fast kinetics, thus, the reaction rate is therefore dominated by the turbulent flow concentration. In addition, the Discrete Ordinates method is used to model thermal radiation phenomena. The flow behavior of fuel, air, and the combustion gases as well as the combustion reaction are modeled and analyzed the ANSYS FLUENT program. In this study, the experimental results of internal burner temperature at 300 kW were used to validate the simulation results from CFD. The simulation results showed that the flames in the burner are spiraled out before converging into the flame lines in the main combustion chamber. The maximum temperature inside the main combustion chamber was 1637 °C and the maximum temperature at the burner inside the pre-combustion chamber was 1370 °C, which was slightly higher than the results from experiment at 1325 °C. The first-law combustion efficiency of this burner was found to be 80% primarily due to incomplete combustion, energy loss from excess air, and unburned coal particles leaving the combustion chamber. The results of this study will be used as a body of knowledge for further analysis of combustion characteristics of pulverized coal and for the improvement of pulverized coal burners in the future.