Abstract:Industrial pulverized coal boilers play an important role in the use of distributed energy, but still suffer from severe pollutant emissions, combustion instabilities and poor fuel adaptabilities. In this paper, numerical simulation and full-scale experiments were carried out to study the recirculating and combustion characteristics of a novel reverse-jet swirl pulverized coal burner with an adding bluff body and flexibly adjusted secondary air. The axial velocity stagnation contour and the out-of-plane vorticity contour were used to characterize the recirculation structure of reverse swirl flows. The original design achieves a moderate char burnout with the carbon content in fly ash to be 18.63% under a residence time of 0.158 s, which demands for the further improvements. However, if only the injection velocity of the secondary air is increased by halving the axial range of the swirl vane, the recirculating flow is strengthened to such an undesired degree that coal ignition appears in the primary air pipe, the burner-wall overheating and near-wall particle enrichment can occur. To overcome it, a bluff body was incorporated with the enhanced secondary air flow. The recirculation zone was restricted downstream the bluff body, thus eliminating possible early coal ignition. Besides, the width of the recirculating flow is broadened, resulting in a more stable combustion with a less fluctuated pressure signal at the furnace exit. The near-wall coal particle concentration is reduced by approximately 90%. As a result, the use of bluff body decreased the carbon content in fly ash to 8.55% by increasing the coal particle residence time to 0.171 s. In addition, the NO concentration at the burner outlet is decreased by 8% owing to a longer coal particle residence time in the reducing environment.

Cold Gas-Particle Flows in a New Swirl Pulverized Coal Burner by PDPA Measurement

Experimental studies on gas-particle flows in a swirl burner by PDPA measurements

Experimental study on cold two-phase flow in swirl burner exit

Flow Characteristic Of A New Type Of Double-Channel Air Burner In Direct Flow Pulverized Coal Boiler

Experimental Measurement of Gas-Solid Two-Phase Flow of a Swirl Burner by Optical Wave Method

Numerical Investigation of Gas-Particle Flow in the Primary Air Pipe of a Low NOx Swirl Burner – the DEM-CFD Method

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

Studies of Pulverized Coal Concentration Measurement in 660MW Boiler Coal Pipe

Recirculating Structures and Combustion Characteristics in a Reverse-Jet Swirl Pulverized Coal Burner

Experimental Study of Particle-Laden Turbulent Reacting Flow in a Swirl Combustor

Analysis of Gas-Assisted Pulverized Coal Combustion in Cambridge Coal Burner CCB1 Using FPV-LES

Flamelet LES of a Swirl-Stabilized Multi-Stream Pulverized Coal Burner in Air and Oxy-Fuel Atmospheres with Pollutant Formation

PDA research on a novel pulverized coal combustion technology for a large utility boiler

Numerical Simulation of Gas-Particle Flows with Different Swirl Numbers in a Swirl Burner

Investigation on Ignition Behaviors of Pulverized Coal Particles in a Tubular Swirl Burner

Experimental and Numerical Investigation of the Non-Reacting Flow in a High-Fidelity Heavy-Duty Gas Turbine DLN Combustor

Experimental study on the effect of particle size on the exit flow field of a swirl burner

Investigation of two-phase flow mixing mechanism of a swirl burner using an electrostatic sensor array system

Experimental Research Of Controllable Pulverized Coal Rich/Lean Swirl Combustion Technology

Experimental Study of O2/CO2 Swirled Burner of Pulverized Coal on Flow Field and Combustion

Measurements of Swirling Coal Combustion and NO Formation