Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Surface modification of nanometer titanium dioxide

Effect Of Surface Modification Of Titanium Dioxide On The Uv-C Aging Behavior Of Silicone Rubber

PREPARATION OF NANO TiO2 ON SURFACE OF SILICA

Surface Organic Modification of SiO2 ＆ Al2O3 Coated TiO2 Particles with Titanate Coupling Reagent

Structure and properties of wet modified titanium dioxide with silane coupling agent KH-570

Modification of Titanium Dioxide Nanoparticles with 3-(Trimethoxysilyl)propyl Methacrylate Silane Coupling Agent

Organic modification of ultrafine particles using carbon dioxide as the solvent

Study on synthesis and modification of Ti/Ce composite oxide

Surface Chemical Modification of Nanosized Oxide Particles with A Titanate Coupling Reagent in Isopropanol

Organic Modification On The Sub-Micron Particles Of Tio2 Pre-Coated With Sio2 And Al2o3

The Adsorption and Reaction of a Titanate Coupling Reagent on the Surfaces of Different Nanoparticles in Supercritical CO2.

Surface roughening and top opening of single crystalline TiO2 nanowires for enhanced photocatalytic activity

(001)-Exposed TiO2 Microcrystals Decorated with Few-Layer Nanobelts for Enhanced Photocatalytic Activity

Surface modification of titanium dioxide photocatalyst

Surface Modification of CaCO3 by Ultrasound-Assisted Titanate and Silane Coupling Agents

Application of Mono-alkoxy Titanate Coupling Agents in Composite Materials

Organic modification of nano-SiO2 particles in supercritical CO2

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Surface modification of TiO2 for the preparation of full-dull polyamide-6 polymers

One-Step Synthesis and Characterization of Titanium Dioxide Powder for Plastic Modification

Study on modification of nano-TiO_2 coated on surface of purified diatomite