Abstract:Titanium dioxide (TiO2) nanoparticles have recently appeared in PET waste because of the introduction of opaque PET bottles. We prepare polymer blend nanocomposites (PBNANOs) by adding hydrophilic (hphi), hydrophobic (hpho), and hydrophobically modified (hphoM) titanium dioxide (TiO2) nanoparticles to 80rPP/20rPET recycled blends. Contact angle measurements show that the degree of hydrophilicity of TiO2 decreases in the order hphi > hpho > hphoM. A reduction of rPET droplet size occurs with the addition of TiO2 nanoparticles. The hydrophilic/hydrophobic balance controls the nanoparticles location. Transmission electron microscopy (TEM_ shows that hphi TiO2 preferentially locates inside the PET droplets and hpho at both the interface and PP matrix. HphoM also locates within the PP matrix and at the interface, but large loadings (12%) can completely cover the surfaces of the droplets forming a physical barrier that avoids coalescence, leading to the formation of smaller droplets. A good correlation is found between the crystallization rate of PET (determined by DSC) and nanoparticles location, where hphi TiO2 induces the highest PET crystallization rate. PET lamellar morphology (revealed by TEM) is also dependent on particle location. The mechanical behavior improves in the elastic regime with TiO2 addition, but the plastic deformation of the material is limited and strongly depends on the type of TiO2 employed.

One-Step Synthesis and Characterization of Titanium Dioxide Powder for Plastic Modification

Study on in-situ Modification of Vinyl Acetate-Acrylate Latex by Anatase TiO2 Sol

Effect Of Surface Modification Of Titanium Dioxide On The Uv-C Aging Behavior Of Silicone Rubber

Study on synthesis and modification of Ti/Ce composite oxide

Preparation of TiO2/SiO2 Composite by Chemical Coating Method

Improvement in the physicochemical properties of titanium dioxide by surface modification with 1H-1-carboxylate of isopropyl-imidazole and 3-aminopropyltrimethoxysilane: case study—as a filler in polylactic acid composites

Study on modification of nano-TiO_2 coated on surface of purified diatomite

Preparation and Characterization of Silica-modified Titanium Dioxide Nanoparticles by Co-precipitation Method

Facile synthesis of mesoporous titanium dioxide nanocomposites with controllable phase compositions by microwave-assisted esterification

Structure and properties of wet modified titanium dioxide with silane coupling agent KH-570

Preparation and Properties of TiO2/illite Composites Synthesized at Different Hydrothermal Ph Values

Synthesis and characterization of mesoporous titanium dioxide

Organic modification of ultrafine particles using carbon dioxide as the solvent

Surface Modification Oftio(2)Particles With 12-Hydroxy Stearic Acid And The Effect Of Particle Size On The Mechanical And Thermal Properties Of Thermoplastic Polyurethane Urea Elastomers

Surface Organic Modification of SiO2 ＆ Al2O3 Coated TiO2 Particles with Titanate Coupling Reagent

Advance of Inorganically coated TiO2 Powder

Highly Photocatalytic TiO 2 Interconnected Porous Powder Fabricated by Sponge-Templated Atomic Layer Deposition

Study on Properties of Compound Inorganic Pigment of Titanium Dioxide/White Mineral Powder

Surface modification of TiO2 for the preparation of full-dull polyamide-6 polymers

Organic Modification On The Sub-Micron Particles Of Tio2 Pre-Coated With Sio2 And Al2o3

The Effect of Titanium Dioxide Surface Modification on the Dispersion, Morphology, and Mechanical Properties of Recycled PP/PET/TiO2 PBNANOs