Abstract:Based on first-cracking criterion and steady-cracking criterion constructed from the micromechanical model, ultra-high toughness cementitious composites material, abbreviated as UHTCC, is tailored even in case of low fiber volume faction, typically 2% by volume. This material is characterized by the pseudo tension strain-hardening under direct tension, and has high ultimate tensile strain capacity up to 3%-5%, and narrow crack width of only 60-80 μm at ultimate tension load. These advantages allow the transform of macro harmful crack into micro harmless crack and UHTCC therefore is considered to be a new promising solution to durable structures. The present paper investigated the flexural behavior of three groups of UHTCC/RC composited beams with three different reinforcement ratios, in which concrete in the region of tension zone of RC beam is partly replaced by UHTCC. The flexural load-carrying capacity, deformation ability, deformation compatibility between steel and UHTCC along with crack development in beam during the entire loading process are examined. For comparison, the ordinary reinforced concrete beams are tested as control reference, too. The experimental results reveal that, in case of the same reinforcement ratio, RC beam strengthened with UHTCC has high flexural capacity and can efficiently control crack width to obtain high durable structures in comparison with ordinary reinforced concrete beam. Moment-curvature curves and load-mid-span displacement curves of tested UHTCC/RC composited beams are calculated using the analytical formulae developed based on beam theory and compared with the experimental measurements. A good agreement between them is found.

Development of assembled permanent formwork using ultra high toughness cementitious composites

Development of Reinforced Ultra-High Toughness Cementitious Composite Permanent Formwork: Experimental Study and Digital Image Correlation Analysis

Potential Use of Strain Hardening Ecc in Permanent Formwork with Small Scale Flexural Beams

Effects of controlled permeability formwork on surface properties and early age shrinkage of concrete

Performances of Concrete Columns with Modular UHPC Permanent Formworks Under Axial Load

A Design Concept with the Use of Ruhtcc Beam to Improve Crack Control and Durability of Concrete Structures

Experimental study on the flexural performance of concrete beam strengthened with ultra high toughness cementitious composites

Improvement of the flexural and cracking behavior of RC beams using ultra-high toughness cementitious composites(I):theoretical analysis

Experimental study of cast-in-situ concrete composite beam with wire mesh permanent formwork

Enhancing Interface Shear Performance and Bending Resistance of UHPC Permanent Formwork for Composite Short Beams by Different Interface Treatment

Strengthening of reinforced concrete structure using sprayable fiber-reinforced cementitious composites with high ductility

Four Point Bending Experimental Investigation on Reinforced Ultra High Toughness Cementitious Composite Beams

Flexural Behaviors of Rc Beams Strengthened with Post-Poured Uhtcc Layer

Analysis and experiment of reinforced ultra-high toughness cementitious composite flexural members

A review on the development of research and application of ultra high toughness cementitious composites

Improvement on flexural and cracking behavior of RC beam using ultra-high toughness cementitious composite Ⅱ: experimental study

Deformation Calculation Of Ultra-High Toughness Cementitious Composite-Concrete Beam Under Flexure Fatigue With Ultra-High Toughness Cementitious Composite Fatigue Damage Model

I-shaped ECC/UHPC composite beams reinforced with steel bars and BFRP sheets

Interfacial Properties of Three-Dimensional-Printed Permanent Formwork with Cast-in-Place Concrete

Flexural Behavior of Uhpc-Rc Composite Beam

Flexural Performance of UHPC–Concrete–ECC Composite Member Reinforced with Perforated Steel Plates