Abstract:The condensation water-bridge phenomenon of the heat exchanger surface fins is a common undesirable phenomenon in refrigeration systems and heat pump systems, which would significantly affect the heat exchanger's thermal efficiency due to insulation and obstruction of airflow. Based on the lack of experimental studies on louvered-fin heat exchangers and surface energy for fin-surface condensation, this paper experimentally investigates the effect of wettability (surface energy) on the condensation mechanism and heat exchanger performance. Firstly, hydrophilic and hydrophobic coatings are formed by reagent deposition, which regulates the surface energy of the fins. Experiments are designed to investigate the effect of surface energy on heat exchanger performance at different temperatures, humidity, and wind speed. Finally, the key issues such as condensation morphology are discussed in detail by molecular dynamics simulation, thus filling the gap and providing a reference for heat exchanger surface construction. The experimental results show that the wet condition has a faster condensation rate, with an average rate reduction of 33.2%. Both hydrophilic and hydrophobic fins could improve the performance of the heat exchanger compared to bare fins due to their inherent uniqueness. The hydrophilic fins have a smaller pressure drop, maintain a more stable heat transfer rate, and improve the heat transfer performance by 13.4% in a typical environment (60%) or with lower water content. While the hydrophobic fins show advantages in a wet environment (80%), improving the heat transfer performance by 17.8% due to the severe deterioration of the bare heat exchanger performance. Further, molecular-scale condensation patterns were analyzed, and condensation rates and adsorption forces were quantified. The experimental and simulation results guide the construction and selection of surface energy to optimize the heat transfer surface.

Observation and Description of the Shape of Water Bridge Retaining Between Vertical Plane Surfaces

Experimental Study and Numerical Analysis of A Composite Bridge Structure

Visualization and prediction model on shape of liquid bridge

A Mathematic Model for Predicting the Volume of Water Bridge Retaining Between Vertical Fin Surfaces

Model for calculating water bridge volume retained between vertical fins

Numerical model of dusty-water bridge forming between neighbor fins of fin-and-tube heat exchangers

Lateral and Normal Capillary Force Evolution of a Reciprocating Liquid Bridge

Molecular Dynamics Simulation and Experimental Study of Heat Transfer and Phase Change of Water with Slit Effect

Fin design for fin-and-tube heat exchanger with microgroove small diameter tubes for air conditioner

Numerical Simulation of Hydrodynamic Pressure on Concrete Bridge Pier in Water from a Series of Model Tests

Experimental Study on the Freezing Process of a Supercooled Horizontal Water Bridge Between Cold Fins

Mechanics Model and Stress Analysis of Rectangular Vessel with Internal Fins

Experimental Study of the Effects of Structured Surface Geometry on Water Spray Cooling Performance in Non-Boiling Regime

Structure Design and Optimizing Simulation of a New Type Closing-to-wall Air Device

Experimental and Numerical Investigation of Thermal -Hydraulic Performance in Wavy Fin-and-flat Tube Heat Exchangers

Numerical simulation of heat transfer and flow characteristics for plate fin-and-tube heat exchanger with ring-bridge slit fins

Thermal boundary conditions for heat transfer analysis of bridges considering non-uniform distribution of internal air temperature by computational fluid dynamics

Experimental Investigation of Heat Transfer Characteristics of Louver Fin-and-tube Heat Exchanger with 5 Mm Diameter Tubes under Wet Conditions

Experimental Study of the Air Side Performance of Fin-and-Tube Heat Exchanger with Different Fin Material in Dehumidifying Conditions

Airside Heat Transfer and Friction Characteristics for Enhanced Fin-and-tube Heat Exchanger with Hydrophilic Coating under Wet Conditions

Numerical Model for Liquid Droplet Motion on Vertical Plain-Fin Surface