Abstract:Shell-and-tube heat exchangers are the most common type of heat exchangers in oil refineries and other large chemical processes. In this manuscript, we demonstrate that the shell-side flow in a cylindrical shell was not as homogeneous as that in a rectangular shell. According to the periodic flow field and the arrangement of tubes in the rectangular shell, the solid-fluid coupling heat transfer model consisting of a single tube section and the outer and inner fluids was developed to represent the whole heat exchanger. Using this model, the relationship among four temperatures, namely the inlet and outlet temperatures of tube-side fluid and the upstream and downstream temperatures of shell-side fluid, was established. By dividing each tube into several tube sections at the sites of baffles, a method for predicting the temperature field of the rectangular shell-and-tube heat exchanger was proposed. Based on the node temperature correlation, all the node temperatures were obtained by iterative computation using the established relationship between the four temperatures and the operating conditions. It was found that the temperature distribution of the fluid in tube was approximately linear along axial direction, but the temperature of tube showed nonlinear regularity. The axial deformation compatibility condition for the tube bundle and shell was considered when resolving the stresses in tubes. For the model established in this paper, the mean temperature of the tube at lower position was found to be larger than that at higher position; hence the thermal expansion of the tube at the lower end is larger. In the case the tube-side fluid was heated, all tubes were pulled because of the larger axial thermal expansion of shell, and the stress in the tube with higher temperature is smaller because of the smaller strain.

Visualization and prediction model on shape of liquid bridge

A Mathematic Model for Predicting the Volume of Water Bridge Retaining Between Vertical Fin Surfaces

Model for calculating water bridge volume retained between vertical fins

Observation and Description of the Shape of Water Bridge Retaining Between Vertical Plane Surfaces

Numerical model of dusty-water bridge forming between neighbor fins of fin-and-tube heat exchangers

Simulations of Interaction Between Flow and a Thin Elastic Beam Using Cip-Based Model with Adaptive Mesh

Numerical Model for Liquid Droplet Motion on Vertical Plain-Fin Surface

Numerical Simulation of Fluid-Elastic Instability in Heat Exchanger Tube Bundles

Three-dimensional Hydrodynamic Model of Concrete Tetrahedral Frame Revetments

Liquid-migration Based Model for Predicting the Thermal Performance of Spiral Wound Heat Exchanger for Floating LNG

Temperature Field Prediction of Rectangular Shell-and-Tube Heat Exchanger

A 3-D model for the prediction of flow separation in fluid machinery

Model Analysis on the Performance of Fin-tube Heat Exchanger with Variable Condition/Structure

Prediction and analysis of thermal-hydraulic performance with slit fins in small diameter (3 mm to 4 mm) heat exchangers

Two-dimensional numerical model for predicting fouling shape growth based on immersed boundary method and lattice Boltzmann method

Numerical Model of Condensate Water Droplet Motion on Fin Surface under Dehumidifying Conditions

A prediction model based on data-driven method for velocity and heat transfer coefficient of falling-film liquid on horizontal tube

Numerical Prediction and Analysis of the Dynamic Behavior of Heat Exchangers with Continuous Helical Shaped Baffles

Modelling and Prediction on the Modal and Harmonic Response of Helix Tube in Large-Scale Spiral-Wound Heat Exchangers

Mechanics Model and Stress Analysis of Rectangular Vessel with Internal Fins

General Prediction of the Thermal Hydraulic Performance for Plate-Fin Heat Exchanger with Offset Strip Fins