Abstract:The use of welded I-section steel members with longitudinally profiled (LP) steel plates is becoming popular in structures, and such members are manufactured with variable thickness to accommodate the loading distributions in practical construction. Compared with the constant thickness steel plates, the use of LP steel plates is more susceptible to local buckling at the thinner end. However, there was no study that reported the local buckling behaviour of such members. Furthermore, existing design codes do not provide any design guidance for calculating the strength of such steel members. In this paper, a total of sixteen welded I-shaped section stub columns with LP and constant thickness steel plates under axial compression were tested to study the local buckling behaviour of such members. The initial geometric imperfections of all specimens were measured using 3D laser scanning technology prior to the axial compression experiments. A nonlinear finite element (FE) model was also established, and validated against the corresponding experimental results, which showed a good agreement both in terms of ultimate strength and failure modes. An extensive parametric study including 130 FE models was conducted using validated FE models. To evaluate the feasibility and reliability of the existing design provisions for steel members with constant thickness steel plates, the test and numerical results were compared against design strength predicted from the existing design provisions. Upon comparison, the existing design formulas in Chinese Standard (GB 50017-2017), American Specification (ANSI/AISC 360-10) and European Standard (BS EN 1993-1-5) are found to be generally conservative when calculating the strength of such members with LP steel plates. New design formulas are proposed, in which the modified normalized slenderness ratio and enhancement coefficient are applied to the existing design provisions.

In-Plane Behavior of Cold-Formed Thin-Walled Beam-Columns with Lipped Channel Section

Experimental and Numerical Study of 7A04-T6 Extruded Aluminium Alloy Lipped Angle Columns in Axial Compression

LOCAL AND DISTORTIONAL BUCKLINGS OF DIFFERENT INCLINED LIPPED PURLINS

Column tests of cold-formed steel non-symmetric lipped angle sections

Cold-formed steel lipped channel columns at elevated temperatures

Buckling behavior of cold-formed steel sigma and lipped channel section beam-columns: Experimental and numerical investigation

BEHAVIOUR OF HIGH STRENGTH COLD-FORMED STEEL COLUMNS UNDER ELEVATED TEMPERATURES

Compressive Behavior and Design Calculations of CFST Slender Columns with Latticed Annular Steel Part

Design of Cold-Formed Steel Built-Up Closed Sections with Intermediate Stiffeners

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Behavior of Thin-Walled Dodecagonal Section Double Skin Concrete-Filled Steel Tubular Beam-Columns

Numerical Investigation Of Lipped Channel Stiffened Bend Members - Part 1: Typical Section Analysis

Local Buckling Tests on Cold-Formed Steel Beams

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

LOCAL BUCKLING OF THIN-WALLED HIGH STRENGTH STEEL COLUMNS WITH WEB STIFFENERS

Compression Tests Of Cold-Formed Steel C- And Z-Sections With Different Stiffeners

Cold-Formed Steel Built-Up Closed Sections With Intermediate Stiffeners

Stub Column Tests of Thin-Walled Complex Section with Intermediate Stiffeners

Local buckling behaviour of welded I-section steel stub columns with longitudinally profiled steel plates under axial compression: Testing, modelling and design

Experimental and Numerical Investigation of Axially Loaded L-shaped Box-T Section Columns