Abstract:Alloy elements can influence the microstructure evolution of aluminum alloys in the state of solid solute atoms or nano-precipitated silicon particles, but it is still a controversial subject which form has a more significant effect on the microstructure of aluminum alloys. Therefore, taking the Al-1%Si alloy as the research object, the ratio of precipitation state and the solid solution state of the silicon atoms was changed before deformation and a multi-pass accumulative roll-bonding method was used to achieve large deformation. In order to compare the influence of solid solute atoms and nano-precipitated silicon particles on the structure and properties of aluminum alloy during deformation, a comparative study was conducted on the evolution of nano-precipitated silicon particles, grain size, and dislocation density in the process of reaching the saturation state of the microstructure and mechanical properties. The results show that the initial samples with less nano-precipitated silicon particles and more solute silicon atoms have a higher saturated dislocation density and a smaller saturated grain size after deformation, corresponding to a higher saturated yield strength. Solid solute silicon atoms dispersed in the Al-1%Si alloy have a better overall effect than nano-precipitated silicon particles of the same volume in preventing the dynamic recovery of dislocations, which is consistent with the theoretical analysis of dislocations. The dislocation recovery ability in the material affects its saturated grain size. The stronger the dislocation recovery capacity, the larger the saturated grain size.

Investigation on Structures of Aluminum Melts Containing Small Amount of Silicon Element

MD Simulation and Transport Property Analysis of Silicon in High-Temperature Molten Fluoride Salts Electrolyte

Dynamic Investigation of the Finite Dissolution of Silicon Particles in Aluminum Melt with A Lower Dissolution Limit

Correlation Between the Local Melt Structure and the Dynamical Properties of Mn, Zn and Si in Liquid Al: an Ab Initio Molecular Dynamics Study

Exploring the Local Structure of Molten Al-Zr-Y(Si) Alloys Using Ab Initio Molecular Dynamics

Structure-Dynamics Relationship in Al-Mg-Si Liquid Alloys

Ab initio simulation: The correlation between the local melt structure and segregation behavior of Fe, V, Ti and Si in liquid Al

Effect of Si content on interfacial reaction and properties between solid steel and liquid aluminum

Investigation of atom distribution in Mg-9wt.%Al melt using small-angle X-ray scattering and molecular dynamics simulation

Molecular Dynamics Simulation of Solution Strengthening of Si and Cu Atoms in Aluminum Alloy

Effect of Alloying Elements on the Short-Range Orders and Atomic Diffusion Behavior of Liquid Al−9Si Cast Alloys

Effect of Silicon State on Microstructure and Properties of Al-1％Si Alloy During Severe Plastic Deformation

Thermodynamics of effect of modification on microstructure of Al-Si alloy melt

The melt structures above the liquidus in SiCp/Al composite

Liquid Structure of Al-Si Alloy: A Molecular Dynamics Simulation

Calculating Models of Mass Action Concentration for Thermodynamic Properties of Phosphorus, Iron and Aluminum in Silicon Dilute Solutions

Effect of Aluminum Doping on the Performance and Microstructure of Methyl-Modified SiO2 Sol

Modification of Silicon Microsegregation in Solid-Solution-Strengthened Ductile Iron by Alloying with Aluminum

Effects of silicon on microstructure, fluidity mechanical properties, and fracture behaviour of Mg-6Alalloy

Influence of Varied Mg/Si Mass Ratio on the Microstructure and Mechanical Properties of Aluminum Die Casting Alloys

Investigation of phase transformation and mechanical properties of silicon addition on AlCrFeMnNi high entropy alloys