Abstract:Unraveling the microstructural heterogeneity is an important issue to understand the physical and mechanical properties of metallic glasses. Structural relaxation below the glass transition temperature Tg and cold rolling at ambient temperature are effective ways to tune the state within the potential energy landscape of metallic glasses, modifying the microstructural heterogeneity. With the help of nanoindentation technique, by scrutinizing the local reduced modulus and hardness of a typical Zr50Cu40Al10 metallic glasses in different energy states (from structural relaxed state to rejuvenated state), we demonstrate that the enhancement of microstructural heterogeneity plays an important role in tailoring the mechanical behavior. The internal friction coefficient is obtained by fitting the experimental load-displacement curves with finite element simulation. It is found that internal friction coefficient decreases with the increase of concentration of flow defects. The stress exponent obtained from the creep stage shows a strong dependence on the structural state of metallic glasses. Effects of structural relaxation and rejuvenation on the structural state are rationalized in terms of the relative flow defects concentration. Finally, the statistics of discrete displacement bursts during the deformation process were probed. We find that the displacement bursts behavior is sensitive to the structural energy state (microstructural heterogeneity). The displacement bursts phenomenon changes from obvious (relaxed state) to unapparent behaviors (rejuvenated state). By given a physical schematic, the correlation between the displacement bursts size and the shear band size in the local plastic zones is well established, which will lead to a deeper understanding of the rejuvenation-induced plasticity of metallic glasses.

Sample Size Effects on Strength and Deformation Mechanism of Sc75Fe25 Nanoglass and Metallic Glass

Size Effects on Tensile and Compressive Strengths in Metallic Glass Nanowires

Intrinsic Size Effects in the Mechanical Response of Taper-Free Nanopillars of Metallic Glass

Sample Size Matters for Al88Fe7Gd5 Metallic Glass: Smaller is Stronger

Prevalence of Shear Banding in Compression of Zr41Ti14Cu12.5Ni10Be22.5 Pillars As Small As 150 Nm in Diameter

Shear Stability of Metallic Glasses

Uncovering the Inherent Size Dependence of Yield Strength and Failure Mechanism in Micron-Sized Metallic Glass

Size Effect in Pd77.5cu6si16.5 Metallic Glass Micro-Wires: More Scattered Strength with Decreasing Diameter

Effects of size on the mechanical response of metallic glasses investigated through in situ TEM bending and compression experiments

Size Effects on the Compressive Deformation Behaviour of A Brittle Fe-Based Bulk Metallic Glass

Size effects in Cu50Zr50 metallic glass films revealed by molecular dynamics simulations

Shear Band Fracture in Metallic Glass: Sample Size Effect

Unraveling the microstructural heterogeneity and plasticity of Zr<sub>50</sub>Cu<sub>40</sub>Al<sub>10</sub> bulk metallic glass by nanoindentation

Interpreting Size Effects of Bulk Metallic Glasses Based on A Size-Independent Critical Energy Density

Effects of sample sizes on compressive mechanical behaviors of Mg-based bulk metallic glasses

Effect of Size and Aspect Ratio on the Mechanical Properties of Zralnicunb Metallic Glass

Effects of Testing Conditions on the Deformation Behaviour of a Ti-based Bulk Metallic Glass

Atomistic Investigation of Mechanical Properties of Metallic Glass Nanocomposites

Size dependent plasticity of a Zr-based bulk metallic glass during room temperature compression

Plastic Deformation Mechanisms and Size Effect of Cu50Zr50/Cu Amorphous/crystalline Nanolaminate: A Molecular Dynamics Study

Influence of Size-Dependent Free Volume Variation and Distribution on the Thermoplastic Flow Behavior of Zr-based Bulk Metallic Glass