Abstract:In-process geometrical parameters of cutter runout and cutting edges in micro milling are very difficult to be measured online due to the limitations of techniques and operation space. This article presents a deep learning-based method to identify the in-situ cutter runout parameters and cutting edges radii in micro milling without the requirement of complicated and nearly impossible online measurements. The great advancement lies in that the in-situ radii differences in relation to different cutting edges are separately characterized and identified, and then combined with the radial cutter runout model to study the micro milling mechanics. An implicit mapping relationship between the geometrical parameters (i.e. runout parameters and cutting edges radii) and the features of cutting forces is intelligently constructed just by machine learning the theoretical predictions rather than experimental results. The required training data in the intelligent method are predicted by the theoretical cutting force model under different combinations of runout parameters and cutting edges radii. Then, the peak value, valley value and phase width of the predicted cutting forces corresponding to every combination are extracted as crucial features, which are further utilized as inputs of a deep learning model for training the implicit mapping relationship. The runout parameters and radii of cutting edges in actual micro milling are finally identified from the trained relationship just based on the extracted features of measured cutting forces. A series of micro milling experiments conducted with different cutters verify the proposed theoretical method.

Tool Runout and Single-Edge Cutting in Micro-Milling

Tool Runout Effects on Wear and Mechanics Behavior in Microend Milling

Investigation on dynamic tool deflection and runout-dependent analysis of the micro-milling process

Identification of Spindle Runout Parameters in Micro-Ball-End Milling

Tool Run-Out in Micro-Milling: Development of an Analytical Model Based on Cutting Force Signal Analysis

A New Method for Determining the Instantaneous Uncut Chip Thickness in Micro-Milling

Deep learning-based method for characterizing the cutter runout phenomenon in micro milling

Investigation of the tool flank wear influence on cutter-workpiece engagement and cutting force in micro milling processes

Micro-milling force modeling with tool wear and runout effect by spatial analytic geometry

Micro-milling tool wear monitoring under variable cutting parameters and runout using fast cutting force coefficient identification method

Micro-milling Machine Tool,micro-Tool Wear and Cutting Forces in Micro-Machining

Single Edge Cutting Phenomenon and Instantaneous Uncut Chip Thickness Model of Micro-Ball-End Milling

A general on-machine non-contact calibration method for milling cutter runout

Modeling and Experimental Study on the Force of Micro-Milling Titanium Alloy Based on Tool Runout

Theoretical Modeling and Experimental Study of Micro Milling Force Based on Tool Wear Mapping

Theoretical study on the effects of the axial and radial runout and tool corner radius on surface roughness in slot micromilling process

Generic Cutting Force Modeling with Comprehensively Considering Tool Edge Radius, Tool Flank Wear and Tool Runout in Micro-End Milling

A Study on the Micro Tooling for Micro/Nano Milling

Analysis and modeling of cutting force considering the tool runout effect in longitudinal-torsional ultrasonic vibration-assisted 5 axis ball end milling

Generic Cutting Force Modeling Comprehensively Considering Tool Edge Radius, Tool Flank Wear and Tool Runout in Micro-End Milling

The Modelling and Analysis of Micro-Milling Forces for Fabricating Thin-Walled Micro-Parts Considering Machining Dynamics