Micro-milling tool wear monitoring under variable cutting parameters and runout using fast cutting force coefficient identification method

Tongshun Liu,Kunpeng Zhu,Gang Wang

DOI: https://doi.org/10.1007/s00170-020-06272-z

IF: 3.563

2020-11-07

The International Journal of Advanced Manufacturing Technology

Abstract:Extracting discriminative tool wear features is of great importance for tool wear monitoring in micro-milling. However, due to the dependency on tool runout and cutting parameters, the traditional tool wear features are incompetent to monitor the tool wear condition in micro-milling with significant tool runout and varied cutting parameter interactions. In this study, micro-milling cutting force is represented by a parametric model including variable cutting parameters, tool runout, and tool wear. The cutting force coefficient in the model, which is not only discriminative to the tool wear condition but also independent to the tool runout and cutting parameters, is extracted as the micro-milling tool wear feature. To reduce the computation cost, a fast neural network–based method is proposed to identify the tool runout and the cutting force coefficient from the cutting force signal. Experimental results show that the proposed cutting force coefficient–based approach is efficient to monitor the micro-milling tool wear under varied cutting parameters and tool runout.

engineering, manufacturing,automation & control systems

What problem does this paper attempt to address?

The paper attempts to address the issue that traditional tool wear characteristics cannot effectively monitor tool wear conditions during micro-milling due to tool runout and variations in cutting parameters. Specifically:

1. **Limitations of Traditional Methods**: Existing tool wear monitoring methods rely on tool runout and cutting parameters, which cause traditional tool wear characteristics to fail in micro-milling.
2. **Impact of Tool Runout**: In micro-milling, even very small tool runout can significantly alter cutting forces, thereby affecting the extraction of tool wear characteristics.
3. **Variations in Cutting Parameters**: In actual machining processes, cutting parameters (such as feed rate, cutting depth, etc.) may vary, further increasing the difficulty of extracting effective tool wear characteristics.

To address these issues, the paper proposes a new method to monitor tool wear in micro-milling by identifying cutting force coefficients. This method is not only insensitive to tool runout and cutting parameters but also effectively monitors tool wear conditions online.