Abstract:Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, Ahead of Print. In-situ analysis of dissimilar laser welding in overlap configuration, which finds the most frequent application in industry, attracts an increasing attention of the research community. In the present work, emission spectroscopy and high-speed imaging were used to investigate the vapor plume behavior during a Yb:YAG laser pulse on the overlap joint between pure titanium and aluminum alloy A5754. A 15 ms long laser pulse was applied to the overlap joints, where titanium and then A5754 were placed on the top. Correlation of the obtained results with post-mortem observation of the impact zones and with a finite-element model of the keyhole evolution was performed. The combination of these approaches facilitated the development of a comprehensive phenomenological timelines of the processes, along with an evaluation of the efficacy of the employed online methods to discern the involvement of the bottom material with the melted zone. The considered configurations showed very different behavior: with reflective A5754 placed on top, the use of high laser power produced an intense keyhole propagation in bottom titanium plate, inducing rapid mix between the elements, while with titanium on top, the use of lower laser power produced prolongated keyhole stagnation at the interface with reflective A5754. High-speed imaging showed very fluctuating behavior of the plume, where the involvement of the bottom material was traduced either by a drastic drop of thermal and atomic emission after the keyhole tip enters the bottom A5754 plate, or by strong periodic bursts of Ti-rich jet after the keyhole reaches the bottom titanium plate. The results of emission spectroscopy were found in adequation with the involvement of bottom material into the melted zone, however, they are affected by plume fluctuations and by the pollution of the top plate by volatile elements.

Analysis-effective Induction Efficiency of Laser in Pulse Laser-Gta Welding of Titanium Alloy

Thermal Efficiency Analysis for Laser-Assisted Plasma Arc Welding of AISI 304 Stainless Steel

Controlling The Plasma Of Deep Penetration Laser Welding To Increase Power Efficiency

Effect of Focusing Condition on Laser Energy Absorption Characteristics in Pulsed Laser Welding

A Laser-Induced TIG Arc Narrow-Gap Welding Technique for TC4 Titanium Alloy Thick Plates Based on the Spatial Position Control of Laser, Arc and Filler Wire

Formation mechanism of double-critical effect in hollow tungsten arc coaxially assisted by fiber laser welding

Parametric study of the laser energy absorption in high-power laser beam welding

The influence of the arrangement for fiber laser and TIG on the hybrid welding process

Investigation on keyhole stability and surface quality in laser welding of TC4 titanium alloy with adjustable ring-mode (ARM) laser

Effects of heat source configuration on the welding process and joint formation in ultra-high power laser-MAG hybrid welding

Influences of laser on the energy parameters of the electric arc in the case of laser-MIG hybrid welding

The Behavior and Its Control of Plasma Produced During Laser Welding

Effect of laser-arc synergy on melting energy in laser-CMT hybrid welding of aluminum alloy

Keyhole Thermal Behavior in GTAW Welding Process

Research on Welding Quality Optimization of Ultra-High Strength Steel Welding Joint Under Different Laser Energy Inputs

Droplet detachment and motion behaviors in laser-MIG hybrid welding of aluminum alloy

A Study on the Influences of Welding Position on the Keyhole and Molten Pool Behavior in Laser Welding of a Titanium Alloy

Effect of beam defocusing on porosity formation mechanism in laser-MIG hybrid welded titanium alloy joints

Microstructure and Mechanical Properties of Arc Zone and Laser Zone of TC4 Titanium Alloy Laser–TIG Hybrid Welded Joint

Investigation of the Inhibition Mechanism of Process Porosity in Laser-MIG Hybrid-Welded Joints for an Aluminum Alloy

The investigation of laser beam interaction with aluminum/titanium overlap joint