Abstract:AgSbSe2 is a typical member of cubic I–V–VI2 semiconductors, which are known for their extremely low lattice thermal conductivity (κl). However, the low electrical conductivity of AgSbSe2, below ∼10 S cm–1 at room temperature, has hindered its thermoelectric performance. In this work, single-phase AgSbSe2 bulk samples with much higher electrical conductivity were synthesized via self-propagating high-temperature synthesis (SHS) combined with spark plasma sintering (SPS) for the first time. Pb doping through the nonequilibrium process further increases the electrical conductivity to >100 S cm–1. Furthermore, continuously increased effective mass md* can be achieved upon Pb doping because of the multiple degenerate valence bands of AgSbSe2 and the energy-filtering effect induced by in situ-formed nanodots. The simultaneous enhancement of both the electrical conductivity and Seebeck coefficient contributes to an unprecedentedly high average power factor of 6.75 μW cm–1 K–2. Meanwhile, the introduced dense grain boundaries and point defects enhance the phonon scattering and consequently suppress κl, yielding a high ZT value of 1.2 at 723 K in AgSb0.94Pb0.06Se2. This study opens a new avenue for rapid, low-cost, large-scale production of AgSbSe2-based materials and demonstrates that Pb-doped AgSbSe2 prepared via the SHS–SPS method is a promising candidate for thermoelectric applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10508?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10508</a>.Part of the thermoelectric properties of AgSb1–xPbxSe2, temperature-dependent electronic thermal conductivity, Lorentz constant, diffusivity, heat capacity, and the elemental quantitative analysis by EPMA for AgSb1–xPbxSe2 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10508/suppl_file/am0c10508_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Ultra-Fast Synthesis for Ag2Se and CuAgSe Thermoelectric Materials

Facile Synthesis of Monodisperse Cu3SbSe4 Nanoparticles and Thermoelectric Performance of Cu3SbSe4 Nanoparticle-Based Materials

One-step Rapid Synthesis of Cu2Se with Enhanced Thermoelectric Properties

Rapid Synthesis of PbSe by MA and HPS and Its Thermoelectric Properties

Fast, Simple, and Cost‐Effective Fabrication of High‐Performance Thermoelectric Ag2Se through Low‐Temperature Hot‐Pressing

High Thermoelectric Performance of AgSb1-xPbxSe2 Prepared by Fast Non-Equilibrium Synthesis.

Ultra-fast fabrication of Bi2Te3 based thermoelectric materials by flash-sintering at room temperature combining with spark plasma sintering

Chemical Synthesis of Nanostructured Cu2se with High Thermoelectric Performance

High Thermoelectric Performance of AgSb 1– x Pb x Se 2 Prepared by Fast Nonequilibrium Synthesis

Ultralow Thermal Conductivity and Extraordinary Thermoelectric Performance Realized in Codoped Cu3SbSe4 by Plasma Spark Sintering

Combustion Synthesis: A Rapid Way for Preparing Bulk Cu2SnSe3 Thermoelectric Materials

Enhanced Thermoelectric Properties of Cu2SnSe3-Based Materials with Ag2Se Addition

High thermoelectric performance for an Ag<sub>2</sub>Se-based material prepared by a wet chemical method

Fast Preparation of AgxPb20SbTe20 (x = 0.5–3) Component with High Thermoelectric Performance

Ultra-low lattice thermal conductivity and enhanced thermoelectric performance in Ag2−xSe1/3S1/3Te1/3 via anion permutation and cation modulation

Synthesis of SnSe 1– x S x Polycrystals with Enhanced Thermoelectric Properties Via Hydrothermal Methods Combined with Spark Plasma Sintering

Effect of ball milling time on the formation and thermal properties of Ag2Se and Cu2Se compounds

Boosting thermoelectric efficiency of Ag2Se through cold sintering process with Ag nano-precipitate formation

Ultralow Thermal Conductivity of Thermoelectric Compound Ag2BaGeSe4

Synthesis and Thermoelectric Properties of Ag-Doped Snse

An effective synthesis route for high-performance α-MgAgSb thermoelectric material