Abstract:A comparative study of the essential difference,design,and application of boundary effect model (BEM) and size effect model (SEM) was conducted.SEM applies the four different multi-parameter empirical equations to the different ratio of initial crack length and specimen depth α.SEM is limited to a data-fitting function.BEM model involves the use of a unique analytical solution.On one hand,BEM can determine the material parameters-fracture toughness KIC and tensile strength f through the fitting of experimental data.On the other hand,it can establish a complete designed curve that describes the overall fracture of structure based on the identified KIC and f.The effect on three fracture controlled model (f-controlled,KIC-controlled and quasi-brittle fracture) were systematically calculated and analyzed from specimen to structure (size W=25-25000mm).The results show that linear elastic fracture mechanics (LEFM) applies for very long crack and very large structures,and there is no further need for size effect study.The size effect model is only relevant when the crack tip is close to either the front or back boundaries.The so-called "size effect" is only a special case of boundary effect.Based on the results of fracture tests (the specimen size W is 40,93,215 and 500 mm,and the ratio of initial crack length and specimen depth α is 0,0.02,0.075,0.15 and 0.3),the different combination conditions of tested data that BEM systematically studied are adopted to determine the influence law of KIC and f.The results are shown that,values are basically consistent to KIC and f,which have been determined by BEM,when the test data reaches a certain amount and one or two groups of data are removed from the overall data,either the specimens have the different W with same α=a0/W,or the same W but different α=a0/W.The studied results of this paper gave a new ideal to solve the problem that the material parameters cannot be accurately obtained using small size specimen,as well as the problem on predicting the actual structure fracture by using the material parameters.

Theory and application of fracture analysis of interface crack using BEM

DYNAMIC FRACTURE ANALYSIS OF CRACK AT BIMATERIAL INTERFACE

Application of a hierarchical quadrature element method to interface crack analysis in bi-material systems

Application of a Closed-Form Model in Analyzing the Fracture of Quasi-Brittle Materials

DBEM computation of T-stress and mixed-mode SIFs using interaction integral technique

Boundary Element Method For Elastoplastic Analysis Of Bimaterial, Including Interface Crack

A new DBEM for solving crack problems in arbitrary dissimilar materials

Dynamic Experimental Study on Interfacial Crack in Bimaterial

A Numerical Analysis with Scaled Boundary Finite Element Method to Simulate Mixed-mode Crack Propagation for Concrete Beams

Subinterfacial Crack Growth in Bimaterials

Fracture Analysis of Shear Deformable Bi-Material Interface

Essential Difference and Design Application of Boundary Effect Model and Size Effect Model

Study for 2d Moving Contact Elastic Body with Closed Crack Using Bem

Peridynamic modeling of elastic bimaterial interface fracture

Peridynamic analysis of materials interface fracture with thermal effect

Boundary element analysis of small-scale yielding of bimaterial interface crack

The analysis of crack problems with non-local elasticity

Stress intensity factor analysis of interface cracks using X‐FEM

Fracture Analysis of Brittle Materials Based on Nonlinear FEM and Application in Arch Dam with Fractures

SH Wave Scattering from 2-D Fractures Using Boundary Element Method with Linear Slip Boundary Condition

Modeling Pressurized Fracture Propagation with the Isogeometric BEM