Simulation On Non-uniform Velocity DynamicCrack Growing By TDBEM
Zhenhan Yao,Zhihong Zhou,Bo Wang
DOI: https://doi.org/10.2495/be990021
1999-01-01
Abstract:The time-domain dual boundary element method (TDBEM), due to its single-region feature, has been successfully used for simulating crack growth problem M. However the previous work pay little attention to weakly singular integration in TDBEM, which may result in error about several percent . To improve the accuracy of numerical integration, first, the quadratic or biquadratic equations have been derived to find out weakly singular points in an elerm nt, and the element is divided into several integration sections according to he singular points. Each section only has one singular point at the end. Then, a function transformation has been introduced into weakly singular integration of each section to eliminate the singularity. The method is turned out to be simple and the effort needed in programming is little. To show that the whole procedure is correct, a comparison of calculation results with experimental data has b< en carried out. The experimental data on polystyrene crack growth given by Papadopoulos have been chosen as the original data, and they have be en carefully analyzed by using the elasto-plastic FEM and simulating the cau; tic method. The results revealed that if the size of plastic zone around the crack tip has the same order with measured spot, the stress intensity factors (S F) calculated by elastic formulation will deviate from the real values significantly, and have to be corrected. Finally, after comparing SIFs from TDBEM \\ith experimental data, it shows that these two results are in good agreement.