Abstract:Welding of dissimilar metal foils is challenging, especially between high melting temperature and brittle metals. In this study, the direct welding of tungsten foil and tantalum foil was achieved using metal protection plates in an explosive welded configuration. The microstructure, chemical composition, and hardness distribution in the corresponding microscopic regions of the W/Ta interface were characterized by electron backscattered diffraction (EBSD), energy-dispersive spectroscopy (EDS), and nano-indentation. The W/Ta interface formed a wavy bonding interface, and a large number of refined grains smaller than 1 µm were created at the interface. Different melting zones were investigated employed EBSD and nano-indentation to understand the vortex structure’s evolution mechanism. It was found that the formation of holes in the melting zone was mainly due to the cooling shrinkage after intense jet agitation. Besides, the more intense jet promotes recovery and recrystallization. However, the stronger intrusion of the jet causes higher nano-hardness in the melt zone, which is attributed to the effect of the jet on the heterogeneous microstructure. Mechanical tests show that the tensile strength of W/Ta bimetal foil exceeds 850 MPa, and there is no crack propagation on the surface of the metal foil. The analysis of welding parameters and material properties revealed that increasing the material temperature during the explosive welding process and providing high-impedance material confinement are the main ways to solve the problem of explosive welding of brittle materials.

Numerical And Experimental Studies On The Explosive Welding Of Tungsten Foil To Copper

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Investigation on the interfacial microstructure and mechanical properties of the W-Cu joints fabricated by hot explosive welding

Microstructure Development During Explosive Welding of Metal Foil：morphologies, Mechanical Behaviors and Mechanisms

Interfacial evolution mechanism of W/Cu explosive welding interface affected by preheating

Performance of fine-grained W/Cu plate prepared by explosive welding with high wave impedance confinement at room temperature

Microstructure Evolution and Mechanical Property of W/Ta Bimetal Foil Produced by a High Wave Impedance Explosive Welding Technology

Experiment and Simulation Investigations on W/Cu Components Prepared by Strong Confinement Thermal Explosive Welding

Experimental Study on the Explosive Welding of Thin Al/Cu Composite Plates

Numerical Simulation of Explosive Welding Using Smoothed Particle Hydrodynamics Method

Experimental Study of Cu/Fe Underwater Self-Constrained Explosive Welding Tube

Experimental and numerical investigations of platinum foil/titanium plate interfaces prepared by explosive welding

Investigation on microstructure and mechanical properties in explosive welded Mo–Cu/Cu interface

Numerical Study on Mechanism of Explosive Welding

Impact Welding of Aluminum AA1060 and Copper T2 Sheets by Vaporizing Foil Actuator: Microstructure, Mechanical Properties, and Electrical Conductivity

Interfacial Microstructure of FeCoNiCrAl0.1 High Entropy Alloy and Pure Copper Prepared by Explosive Welding

Formation of Bonding Interface in Explosive Welding-a Molecular Dynamics Approach.

Numerical and Experimental Studies on the Explosive Welding of Plates with Different Initial Strength

Microstructure and mechanical properties investigation of explosively welded titanium/copper/steel trimetallic plate

Investigation of Tungsten/steel Brazing Using Ta and Cu Interlayer

Microstructure and Grain Evolution Mechanisms of Copper/steel Explosive Welding Interface