Abstract:Summary form only given. As one of the key components in the pulsed power system, the two-electrode gas spark switch has many advantages such aslarge charge transfer, high current capability, stability and long lifetime. But some practical engineering issues, like the extraction of unconventional gas resources, set strictly demands on switch's work environment and output characteristics, such as high current capability, high breakdown voltage stability, long lifetime, high-frequency operation while working in a small airtight chamber without gas blowing system. The performances of the switch directly influence the output characteristics of the system. The electrode erosion of electrodes caused by high current directly influences the performances of the switch. But few studies have done on the effect of different electrode materials on electrode erosion characteristics and failure modes of gas spark switch. Analyses of the physical characteristics and chemical characteristics of different electrodes' surfaces at different stage of life were shown. By analysing the erosion characteristics and special failure phenomenon of electrodes, some relationships between different electrode materials and failure modes were proposed. to investigate the Cu-W (90 wt%) two-electrode spark-gap switch working in an airtight cavity (1.18 L) without gas blowing system. A test stand was established and could been divided into five parts, a DC power, a pulse capacitor, a two-electrode gas spark switch, a low inductance load resistor and measurement systems. The gas spark switch was working in an airtight cavity (1.18 L) without gas blowing system. The switch was tested with frequency of 0.1 Hz, self-breakdown voltage of 30 kV, peak current of 50 kA. A scanning electron microscope and a Dynamic 3D aspheric profiler were used to observe the surface roughness of the electrodes. A Bruker Tensor 27 FT-IR Spectrometer and an X-ray photoelectron spectroscopy were used to analyze the chemical composition of erosion product.

Note: Erosion of W-Ni-Fe and W-Cu Alloy Electrodes in Repetitive Spark Gaps

A Further Study on Surface Morphology and Erosion Products of 90wcu Alloy Electrodes

Experimental and Numerical Simulations of ELM-like Transient Damage Behaviors to Different Grade Tungsten and Tungsten Alloys

Surface Morphology of Cu-W Alloy Electrodes in a Long Lifetime Gas Spark Switch

Influence of Surface Morphology and Microstructure on Performance of CVD Tungsten Coating under Fusion Transient Thermal Loads

Effect of Different Electrode Materials on Electrode Erosion Characteristics and Failure Modes of Gas Spark Switch

Investigation of WCu Electrode Erosion Morphology under Impulse Arcs

Electrode erosion of a high energy impulse spark gap switch

Erosion of Stainless Steel Electrodes in a High-Repetition-rate Gas Spark Switch

Experimental Study of Electrode Erosion and Aging Process of a Specially Designed Gas Switch under Repetitive Arc Discharge

Splashing Characteristics of Microparticles from Electrode Erosion for Copper, Molybdenum, and Tungsten-Copper

Performance and Microstructure of TiN/Cu EDM Electrodes

Effect of pulse current parameters on electroplastically assisted dry cutting performance of W93NiFe alloy

Simulation of Cathode Spots Crater Formation on Electrodes with Micro-Scale and Nano-Scale Alloy Materials in a Vacuum Arc

Study on the arc erosion resistance and mechanism of Cr- doped W Cu composites

Study on the Characteristics of the Gas Switch Electrode Erosion

Surface Changes in Fe–Cr–Ni Alloy Bombarded by Relativistic Pulsed Electron Beam and Associated Mechanism

Low Electrode Erosion Rate of Nanocrystalline Cucr-50 Alloy in Vacuum

Arc ablation resistance behavior of Cu-W alloys with different W contents under atmospheric environment

Cucr1 Alloy Surface Hardening Via Ultrasonic Assisted Electro-Spark Deposition

Study on the Erosion Characteristics of Copper‐carbon Electrode Pairs by DC Air Arc