Abstract:Based on the concept that NiTi shape memory alloys(SMAs) are substantially heterogeneous and there inevitably exist residual micro residual stress fields,and the superposition of the residual stress and the stress induced by applied thermal-mechanical loads may cause martensitic transformation at low level of applied thermal-mechanical loads,a new transformation driving force model is proposed for an existing description for martensite variants in NiTi SMAs.The corresponding numerical algorithm is developed and the pseudoelasticity of NiTi SMAs is analyzed,and compared with experimental results and the results by Gall et al.In the proposed model the transformation driving force is considered as a continuous function of martensite volume fraction,however,the transformation as well as its rate is insignificantly small as the transformation driving force is far from its saturated magnitude.Analysis shows that the range of the transformation driving force with respect to prescribed tolerance of transformation volume fraction is much smaller that that adopted in the existing work,and vice versa,indicating higher computation accuracy of the proposed approach.On the other hand,no assessment is needed for the occurrence of the transformation and its direction in each variant a priori,which is significant in computation,especially in the case of multiaxial thermal-mechanical loading.Since the proposed approach avoids the discontinuity in the evolution of the transformation driving force at the instant when transformation starts,and the additional numerical process for the identification of the variants where transformation proceeds or not,it can not only simplify the numerical process,but also enable the computation process be more stable and efficient.

An Analysis of Residual and Transformational Stresses in SMA Composites

Micromechanical Modelling of Shape Memory Alloy Composites

TRANSFORMATION BEHAVIOR OF COMPOSITES REINFORCED IN SMA SHORT FIBERS UNDER THERMAL LOAD CONDITIONS

Effect of Thermomechanical Coupling on Stress-Induced Martensitic Transformation Around the Crack Tip of Edge Cracked Shape Memory Alloy

Studying the Thermomechanical Behavior of Sm Composites with Aligned Sma Short Fibers by Micromechanical Approaches

Micromechanics of Composites Reinforced in the Aligned SMA Short Fibers in Uniform Thermal Fields

THERMAL EXPANSION COEFFICIENT AND TRANSFORMATION STRAIN COEFFICIENT OF COMPOSITES REINFORCED BY SMA SHORT FIBERS

Analysis of a Shape Memory Alloy Plate with a Circular Hole Subjected to Biaxial Tension

Creep and Thermal Stress Analysis of the SMA Joint System

One-dimensional modeling of stress-induced transformation behaviour of shape memory alloy

A Thermomechanically Coupled Finite Deformation Constitutive Model for Shape Memory Alloys Based on Hencky Strain

An Extended Thermomechanically Coupled 3D Rate-Dependent Model for Pseudoelastic SMAs under Cyclic Loading

Stress transfer for a SMA fiber pulled out from an elastic matrix and related bridging effect

New Insight into Residual Stresses in Amine-Grafted MWCNTs/binary Resin Composites under Complex Thermomechanical Loadings

Analyses of thermal and residual microstresses between the particles and matrix of composites

Analytical Model for the Winding Process-Induced Residual Stresses of the Multilayered Filament Wound Cylindrical Composite Parts

Analytical Study on the Stress-Induced Phase or Variant Transformation in Slender Shape Memory Alloy Samples

MECHANICAL PROPERTIES OF SMA COMPOSITES EMBEDDED WITH ALIGNED SMA SHORT FIBER IN ELASTOPLASTIC MATRIX

Interface stress transfer model and modulus parameter equivalence method for composite materials embedded with tensile pre-strain shape memory alloy fibers

Characteristics of Stress-Induced Transformation and Microstructure Evolution in Cu-based SMA

A KINEMATIC MODEL AND NUMERICAL ALGORITHM FOR CONSTITUTIVE BEHAVIOR OF SINGLE CRYSTAL SHAPE MEMORY ALLOY