Abstract:The fabrication of fiber-reinforced metal matrix composites (MMCs) mainly consists of two stages: infiltration and solidification, which have a significant influence on the properties of MMCs. The present study is primarily focused on the simulation of the solidification process and the effect of the active cooling of fibers with and without nickel coating for making the continuous carbon fiber-reinforced aluminum matrix composites. The thermomechanical finite element model was established to investigate the effects of different cooling conditions on the temperature profile and thermal stress distributions based on the simplified physical model. The predicted results of the temperature distribution agree well with the results of the references. Additionally, a three-dimensional cellular automata (CA) finite element (FE) model is used to simulate the microstructure evolution of the solidification process by using ProCAST software. The results show that adding a nickel coating can make the heat flux smaller in the melt, which is favorable for preventing debonding at the coating/fiber and alloy interface and obtaining a finer microstructure. In the presence of the nickel coating, the number of grains increases significantly, and the average grain size decreases, which can improve the properties of the resultant composite materials. Meanwhile, the predicting results also show that the interfaces of fiber–coating, fiber–melt, and coating–melt experience higher temperature gradients and thermal stresses. These results will lead to the phenomenon of stress concentration and interface failure. Thus, it was demonstrated that these simulation methods could be helpful for studying the solidification of fiber-reinforced MMCs and reducing the number of trial-and-error experiments.

Analysis Of The Thermo-Residual Stress In Production On Fiber Reinforced Aluminum Matrix Composites

Micro Failure Analysis of Fiber Metal Laminates

Oral/poster reference: icf100247pr

Pretension-Dependent Residual Stress of Alumina Fiber-Reinforced Composite Wire

Finite Element Analysis of Thermal Residual Stress in Unidirectional Fiber Reinforced Composite

Thermal Residual Stresses and Stress Distributions under Tensile and Compressive Loadings of Short Fiber Reinforced Metal Matrix Composites

Finite Element Analysis on Thermal Residual Stress of Particle-reinforced Iron-matrix Composite

A Microscale Analysis of Thermal Residual Stresses in Composites with Different Ply Orientations

Analyses of thermal and residual microstresses between the particles and matrix of composites

Explaining Deviatoric Residual Stresses in Aluminum Matrix Composites with Complex Microstructure

Analytical Investigation of Thermomechanical Stresses in Graded Interphase Between the Fiber and the Matrix

Localization of deformation and formation of residual stresses in metal-matrix composites

Multi-Scale Modeling and Damage Analysis of Composite with Thermal Residual Stress

A Study of the Residual Stress and Its Influence on Tensile Behaviors of Fiber-Reinforced Sic/Al Composite

Numerical Simulation on Thermal Stresses and Solidification Microstructure for Making Fiber-Reinforced Aluminum Matrix Composites

Modeling of thermal residual stresses in multilayer coatings with graded properties and compositions

Residual stresses in coating-based systems, part I: Mechanisms and analytical modeling

Effect of thermal residual stresses on yielding behavior under tensile or compressive loading of short fiber reinforced metal matrix composite

Stress Transfer Model and Micromechanic Analyses of Unidirectional Single-short-fiber Composite

Thermal residual stress in continuous SiC fiber reinforced titanium matrix composites

Formation and Test Methods of the Thermo-Residual Stresses for Thermoplastic Polymer Matrix Composites