Abstract:As an efficient and energy-saving heat exchange technology, horizontal tube falling film evaporation has a great application prospect in refrigeration and air conditioning. The three-dimensional models of falling film flow evaporation outside horizontal single tube and inside evaporator were established, and the accuracy of flow and heat transfer simulation process was verified by comparison. For horizontal single tube, the results showed that total heat transfer coefficient was low and increased with larger spray density and evaporation temperature. The thickness of liquid film outside tube decreased gradually with the increase of tube diameter, and the total heat transfer coefficient of small tube diameter was significantly greater than that of the large tube diameter. The total heat transfer coefficient presented an increasing trend with larger liquid distribution height and density. In addition, the fluctuation of tube axial liquid film thickness distribution decreased with larger liquid distribution density. For evaporator, the results indicated that part of liquid refrigerant was carried into the vapor outlet. The temperature of tube wall and fluid presented a gradually rising trend in vertical downward direction, while tube wall temperature within the same horizontal and transverse row had little difference. The high-temperature zone on the outer wall of heat exchange tube moved towards the inlet and gradually decreased, and the outlet temperature of water in the tube also gradually decreased with the increase of refrigerant spray density. The local heat transfer coefficient of heat exchanger tube in the vertical direction presented a downward trend which was more obvious with the smaller spray density and it was obviously higher located in the middle of upper tube row and both sides of lower tube row for horizontal tube rows.

The Analysis of Two-Phase Flow Instability in a Vertical U-tube Evaporator

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Two-phase flow instabilities in horizontal straight tube evaporator

Numerical Analysis of Two-phase Flow Instability in Evaporating Tube under Non-uniform Heating Condition

Instability Analysis of Evaporating Falling Film Flow in Vertical Tube

Energy analysis of evaporating thin falling film instability in vertical tube

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

Experimental investigation on the convective boiling flow instabilities of steam/water two phase flow in horizontal helically coiled tube

EXPERIMENTAL INVESTIGATION AND FLOW VISUALIZATION OF THE TWO-PHASE FLOW INSTABILITY AT LOW VAPOR QUALITY IN A VERTICAL NARROW CHANNEL

Investigation of two phase flow instability in a narrow channel

Two-Phase Flow Instability of Boiling in A Double Microchannel System at High Heating Powers

Computational Case Study on Upward Two-Phase Flow in Vertical Circular Pipe Based on CFD Approach: Multidimensional Flow Instabilities Investigation

Investigating Flow Instability Mode and Characteristics in a Microchannel Evaporator

Theoretical Analysis and Modeling of Flow Instability in a Mini-Channel Evaporator

Viscous Kelvin–Helmholtz instability analysis of liquid–vapor two-phase stratified flow for condensation in horizontal tubes

Experiment on Density Wave Oscillation Instability of Two-Phase Flow in Low Mass Velocity Parallel Vertical Rifled Tubes

Two-Phase Flow Instability in Vertical and Inclined Parallel Rifled Tubes at Low Mass Velocity

Effects of parameters on the two phase flow instability in a microchannel

Numerical Study on Flow Heat Transfer Characteristics of Horizontal Tube Falling-Film Evaporator

THE EFFECTS OF WALL HEAT FLUX ARRANGEMENT ON FLOW INSTABILITY BOUNDARY IN A VERTICAL SINGLE TUBE

Transient Numerical Simulation and Two-phase Flow Instability Prediction of Convective Boiling in Vertical Up-flow Tube