Abstract:In the project of Hong Kong-Zhuhai-Macau Bridge, the back-silting of natural foundation section is serious, and the tunnel structure is prone to uneven settlement along the longitudinal direction, and the longitudinal depth of the tunnel will be different due to the navigation demand. The traditional flexible joint scheme will cause great deformation of segment joints and reduce the safety reserve of the shear bearing capacity of the joints. Therefore, the Hong Kong-Zhuhai-Macau immersed tunnel has adopted a semi-rigid system design, that is, after the completion of the prestressing construction of segment joints, the prestressing tendons were not be cut off. The pre-stressed reinforcement can not only ensure the opening of segment joints within a certain range, but they are also adapted to the uneven settlement of the seabed. Notably, prestress plays a very important role in the whole immersed tube tunnel. Therefore, this paper is focused on a comprehensive study of the prestress applied in the semi-rigid scheme. A 1:100 small scale model test of the E13 element in the natural foundation of the immersed tube tunnel is taken as an example. Through the study of two factors, the degree of prestress tension and the size of back silting, the settlement characteristics and the distribution of compressive stresses of marine subsoil on the immersed tunnel are analyzed. The results of the model test showed that the increase in the degree of prestress tension is advantageous to management of the stress and uneven settlement of the joints. Through a comparison of the results of different prestress tension values, the rationality behind the selection of semi-rigid tunnel as a practical engineering scheme is demonstrated. This research lays a foundation for further study on the selection and optimal design of immersed tube tunnels, and the results provide a references point for similar immersed tunnel projects.

MODEL TEST RESEARCH OF BASE LAYER COMPRESSION FEATURE IN SUBMARINE IMMERSED TUBE TUNNEL

Model tests on compression of base layer of immersed tube tunnels considering siltation

Summary of Model Tests and Settlement Characteristics of Base Layer in Immersed Tube Tunnel

Face stability analysis of shield-driven tunnels shallowly buried in dry sand using 1-g large-scale model tests

Study of Sedimentation Speed and Compression Characteristics of Back-Silting Soil from Undersea Immersed Tube Tunnels

DISPLACEMENT ANALYSIS OF GEOMEMBRANE BAG WITH SAND SOIL COFFERDAM IN ZHOUSHAN UNDERSEA IMMERSED TUBE TUNNEL

Model Test of Immersed Tube Tunnel Foundation Treated by Sand-Flow Method

Analysis of Settlement Control Measures in Immersed Tunnel

Calculation and Distribution of Vertical Differential Settlement in Immersed Tunnels

Evaluation on the State of Sand Filling Layer and the Influence on Segment Deformation of Immersed Tunnels

MODEL EXPERIMENTAL RESEARCH ON EFFECT OF MATERIAL OF IMMERSED TUNNEL BOTTOM SURFACE ON FOUNDATION FORMED BY SAND-FLOW METHOD

Application of Three-Parameter Model in Settlement Calculation of Immersed Tube Tunnel

Grouting Test Study on Small-Scale Model of the Immersed Tube Tunnel Foundation

STUDY OF DISTRIBUTION CHARACTERISTICS OF SUBSURFACE SETTLEMENT CAUSED BY TUNNEL CONSTRUCTION IN SANDY SOIL WITH MODEL TEST

LAB MODEL TESTS OF SOIL-PIPE INTERACTION IN SANDS BY TUNNELLING

Shaking Table Test and Dynamic Response Analysis of Saturated Soil–Submarine Tunnel

Modeling the Compression Behavior of Dredged Sandy Clays Considering the Effect of Initial Water Contents and Sand Fractions

Study on bearing characteristics of marine subsoil for semi-rigid immersed tunnel

Numerical Modeling Of Wave-Induced Liquefaction Around Immersed Tunnel

Deformation analysis of underwater shield tunnelling based on HSS model parameter obtained by the Bayesian approach

Study on Bearing Capacity of Composite Foundation with Marine Sand Compaction Pile by Centrifugal Test