Abstract:Squeezing problems pose a serious challenge for tunnel engineers because they can slow down a project, increase the project budget, and potentially lead to catastrophic collapse. The choice of an adequate support is also often difficult owing to complex geological environments. Lack of sufficient understanding of geological conditions such as high geostress and horizontal layered rock mass could cause tunnel collapse and further lead to economic loss and endanger human life. In an attempt to deal with in-situ squeezing problem, this paper focus on the investigation of the mechanical behavior of tunneling in horizontal layered rock mass with high geostress and the proposal of proper engineering measures. A tunnel collapse incident occurred in northeastern China is analyzed using comprehensive methods including photographing, laboratory tests, discrete element numerical simulations, and site monitoring. The discrete element method was applied to investigate the tunneling mechanical behavior under high-geostress conditions in a horizontally layered rock mass. Numerical simulations show that the dominant horizontal stress and joints cause the maximum deformation at the corner of the arch region. The effect of horizontal joints and horizontal dominant stress were analyzed and found to be the main causes of the collapse. Based on the simulation results, an innovative, simple and efficient tangential yielding element is developed and implemented to test its applicability in a tunnel engineering scenario. Load-displacement curves of the tangential yielding element were obtained through laboratory tests and introduced to the numerical model using the 3D discrete element method. The performance of the developed tangential yielding element was validated in the simulation. Site monitoring was also conducted to determine the in-situ performance of the yielding support using the tangential yielding element. The monitored settlement at the crown region is in agreement with the simulation. The in-situ tests show that the yielding element was considerably deformed while the tunnel remained stable, which confirms the applicability of this technique. The effectiveness of the yielding element is also confirmed in terms of a comparative cost analysis of the yielding and resistant support schemes.

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

Experimental and Theoretical Study on Longitudinal Deformation and Internal Force of Shield Tunnel under Surcharge

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Model Test on the Influence of Surcharge, Unloading and Excavation of Soft Clay Soils on Shield Tunnels

Tunnel failure mechanism during loading and unloading processes through physical model testing and DEM simulation

Model Design and Application for Excavation Face Stability in Upward Shield Tunneling

Model Test Study on the Influence of Ground Surcharges on the Deformation of Shield Tunnels

A Modified Wedge-Prism Model for Calculating the Limit Support Pressure of a Shallow Shield Tunnel Face in Unsaturated Sandy Soil

An integrated study of physical and numerical modelling on the stability of underground tunnel influenced by unloading rate

Surrounding rock instability mechanism for fault-crossing tunnels in water-rich soft rock

Physical Model Study on Brittle Failure of Pressurized Deep Tunnel with Support System

Experimental Study on Deformation and Failure Characteristics and Monitoring and Early Warning of Surrounding Rock of Tunnel Crossing Sliding Surface

The collapse mechanism in a subsea tunnel passing through the fault: a model test study

Model Test Studies on Ground Subsidence and Cracks Induced by Tunneling in Weak Rock Mass with High Water Content

Deformation and failure of overburden soil subjected to normal fault dislocation and its impact on tunnel

Physical modelling of deformation and failure mechanisms and supporting effects for a deep-buried tunnel in inclined layered strata

Model test study on the dynamic response of surrounding rock in deep buried tunnel under explosive plane wave

Stress-induced collapse in horizontally layered rock and a yielding support strategy: A case study

Modeling of the Effect of Excavation Mode on the Extent of the Anisotropic Zone Surrounding Deep Tunnels

Failure mechanism and stability identification of surrounding rock for soft-rock tunnels using long-footage rapid excavation method

Research on the Mechanism of Loose Deformation in Weak Fracture Zone Tunnel Surrounding Rock and Support Control