Abstract:Additive manufacturing of dense ceramic products has been challenging because of the high polymeric content of the ceramic feedstock materials. Several studies have been conducted to increase the ceramic content in the feedstock, but the binder and additives in it have remained in the polymeric content. A novel strategy for highly dense additive manufacturing using a sol-gel-based ceramic slurry without polymeric additives is presented. Alumina, which is the most widely used fine ceramic, was chosen as a representative ceramic material. The proposed sol-gel solution enabled a high solid loading of approximately 50 vol% without any polymeric dispersant while satisfying the requirements for material extrusion process, such as extrudable viscosity (<100 Pa.s) and self-sustainable yield stress. This novel sol-gel binder system evolves into aluminum oxide nanoparticles during the sintering process, eventually fusing to the alumina particles. The as-printed green body possessed high alumina content and 66% of theoretical density, which was higher than that obtained via the conventional molding methods. A reduced linear shrinkage of less than 16% and a high density of 99.5% of the theoretical value were also achieved. This research would present a practical strategy for ceramic additive manufacturing as an emerging fabrication process.

Fabrication of complicated ceramic parts by gelcasting based on additive manufactured acetone-soluble plastic mold

Fabrication of Three-Dimensional Inter-Connective Porous Ceramics Via Ceramic Green Machining and Bonding

Ceramics with Ultra‐Low Density Fabricated by Gelcasting: an Unconventional View

Fabrication of Porous Zirconia Ceramics by Injection Molding Method

Solid freeform fabrication of alumina ceramic parts through a lost mould method

Gelcasting Based Solid Freeform Fabrication of Piezoelectric Ceramic Objects

Porous Yttria‐stabilized Zirconia Ceramics Fabricated by Nonaqueous‐Based Gelcasting Process with PMMA Microsphere As Pore‐Forming Agent

Additive manufacturing of dense zirconia ceramics by fused deposition modeling via screw extrusion

Preparation of porous ceramics by gelcasting approach

Application of Gelcasting to the Fabrication of Piezoelectric Ceramic Parts

Rapid Prototyping of Piezoelectric Ceramics Via Selective Laser Sintering and Gelcasting

Material extrusion for ceramic additive manufacturing with polymer-free ceramic precursor binder

Effect of Chopped ZrO2 Fiber Content on the Microstructure and Properties of CaO-Based Integral Ceramic Mold

Ceramics with Special Porous Structures Fabricated by Freeze-Gelcasting: Using tert-Butyl Alcohol as a Template

Additive Manufacturing and Characterization of Complex Al2o3 Parts Based on A Novel Stereolithography Method

Fabrication of ZrB 2 -Sic Ceramic Composites by Optimized Gel-Casting Method

Fused deposition fabrication of high-quality zirconia ceramics using granular feedstock

Water based gelcasting of lead zirconate titanate

Study on the Process of Si3N4 Ceramic with High Properties by Gel-casting

Suppression of Surface-Exfoliation by Gelcasting Ceramics with Mixed Polymer-Monomer Solutions

Formation of Silicon Nitride Bonded Silicon Carbide by Aqueous Gelcasting