Abstract:This paper reports an approach of in-operation temperature bias drift compensation based on phase-based calibration for a stiffness-tunable MEMS accelerometer with double-sided parallel plate (DSPP) capacitors. The temperature drifts of the components of the accelerometer are characterized, and analytical models are built on the basis of the measured drift results. Results reveal that the temperature drift of the acceleration output bias is dominated by the sensitive mechanical stiffness. An out-of-bandwidth AC stimulus signal is introduced to excite the accelerometer, and the interference with the acceleration measurement is minimized. The demodulated phase of the excited response exhibits a monotonic relationship with the effective stiffness of the accelerometer. Through the proposed online compensation approach, the temperature drift of the effective stiffness can be detected by the demodulated phase and compensated in real time by adjusting the stiffness-tuning voltage of DSPP capacitors. The temperature drift coefficient (TDC) of the accelerometer is reduced from 0.54 to 0.29 mg/°C, and the Allan variance bias instability of about 2.8 μg is not adversely affected. Meanwhile, the pull-in resulting from the temperature drift of the effective stiffness can be prevented. TDC can be further reduced to 0.04 mg/°C through an additional offline calibration based on the demodulated carrier phase representing the temperature drift of the readout circuit.

A Passively Compensated Capacitive Sensor Readout with Biased Varactor Temperature Compensation and Temperature Coherent Quantization

An All-Digital CMOS Temperature Sensor with a Wide Supply Voltage Range.

An Inaccuracy of +/- 0.5 degrees C Digital Temperature Sensor From-40 degrees C to 125 degrees C With Curvature Correction

A 0.8V Capacitively-Biased BJT-Based Temperature Sensor with an Inaccuracy of ±0.4°C ($\mathbf{3}\mathbf{\sigma}$) from −40°C to 125°C in 22nm CMOS

A CMOS Temperature Sensor with Versatile Readout Scheme and High Accuracy for Multi-Sensor Systems

An Energy-Efficient Capacitively Biased Diode-Based Temperature Sensor in 55-nm CMOS

Capacitor-reused CMOS temperature sensor with duty-cycle-modulated output and 0.38°C ( 3 σ ) inaccuracy

Capacitor-Reused Cmos Temperature Sensor With Duty-Cycle-Modulated Output And 0.38 Degrees C (3 Sigma) Inaccuracy

Temperature Bias Drift Phase-Based Compensation for a MEMS Accelerometer with Stiffness-Tuning Double-Sided Parallel Plate Capacitors

Capacitor‐reused CMOS Temperature Sensor with Duty‐cycle‐modulated Output and 0.38°C () Inaccuracy

A Real-Time Temperature Compensation Algorithm for a Force-Rebalanced MEMS Capacitive Accelerometer Based on Resonant Frequency.

A 1.2V Self-Referenced Temperature Sensor with a Time-Domain Readout and a Two-Step Improvement on Output Dynamic Range

A 14-B BW /power Scalable Sensor Interface with a Dynamic Bandgap Reference

A Dynamic-Biased Resistor-Based CMOS Temperature Sensor with a Duty-Cycle-Modulated Output

An Energy-Efficient BJT-Based Temperature Sensor with +/- 0.8 degrees C (3 sigma) Inaccuracy from-50 to 150 degrees C

A BJT-Based CMOS Temperature Sensor with Duty-Cycle-Modulated Output and ±0.5°C (3σ) Inaccuracy from −40 °C to 125 °C

A Ka-Band Class-C BiCMOS VCO with Temperature Compensation

A Combined Temperature and Capacitance Sensor Interface

A novel temperature compensated piezoresistive pressure sensor

A Fully Integrated Capacitance Boosting Offset Calibration Circuit for Capacitive Pressure Sensor

A 13-Bit Temperature Sensor with a ±1.45°C (3σ) Inaccuracy from -55°C to 125°C