Abstract:Flashover voltage of contaminated insulators relates to the damp degree of pollution layer on the insulators.Humidity and temperature-difference are two typical factors for dirty layer wetting.We introduced the roles of temperature and humidity in about one-hour short-term wetting of contamination layer.A series of artificial pollution trials,including temperature difference trials and humidity trials,were designed in a temperature and humidity controllable fog chamber.A solid layer method was adopted in the artificial pollution tests,during which ceramic suspension insulators XP-70 were contaminated by brushing specified quantity pollution.Experimental results suggest that when relative humidity(RH) does not reach to 100% and RH as the only factor for wetting,wetting process of dirty layer is very slow and one-hour is not enough to fully damp dirty,thus the NaCl in the contamination cannot be dissolved absolutely and the contribution of NaCl to the conductivity of surface pollution is limited.When the RH reaches to 100% with no temperature difference,contamination can be immediately wetted.Researches also show that temperature difference plays an important role during short-term wetting process.The difference between insulators temperature and the dew point of environment directly affects the strength of leakage current.Temperature difference only in the initial period of wetting plays a dominate role.With the disappearing of temperature difference,humidity becomes the leading factor for dirty damp.The maintenance time of temperature difference playing a leading role in wetting is related to the radiating area and specific heat capacity of the test sample.The smaller the specific is,or the larger the radiating area is,the shorter time the temperature-difference works.

Investigation on Theoretical Analysis of Characteristic Parameter Kh10 in Wetting Process of Polluted Composite Insulators

Influence of Temperature Difference on Wetting Characteristics of Insulators

Wetting Characteristics of the Hydrophobic Material Surface Through Condensation

Roles of Humidity and Temperature Difference in Pollution Layer Wetting of Insulators

Study on Electric Field Around Transmission Line Composite Insulators under Polluted and Wet Condition

Natural Pollution Test of Composite and Porcelain Insulators Under AC and DC Stress

Investigation of DC Discharge Behavior of Polluted Porcelain Post Insulator in Artificial Rain

Investigation on Hydrophobicity and Pollution Status of Composite Insulators in Contaminated Areas

Laboratory study on hydrophobicity and pollution flashover properties of polymer insulators

Study on the Polluted Regularity of Insulators Quantitatively Described by Partial Surface Conductivity

Study on the Transference of Hydroplibocity for Kaolin and Kieselgur

Analysis On Flashover Performance Of Polluted Porcelain Insulators In High Conductivity Fog Environment

Pollution Flashover Characteristic of Composite Insulator with Non-uniform Hydrophobicity Distribution on Surfaces

Investigation on Wetting Process of Polluted Composite Insulators

Modeling of Dry Band Formation and Arcing Processes on the Polluted Composite Insulator Surface

Experimental Study on the Pollution Flashover Mechanism of Polymer Insulators

Investigation on Composite Insulators in Contaminated Areas

Artificial pollution test and pollution performance of composite insulators

Analysis of characteristic of natural pollution test and artificial simulation method

Experimental research on pollution flashover voltage and leakage current characteristics of naturally polluted insulators

Surface Roughness Effect on the Hydrophobicity Characteristic of Operating Composite Insulators