Abstract:A 0.1–4 GHz software-defined radio (SDR) receiver with reconfigurable 10–100 MHz signal bandwidth is presented. The complete system design methodology, taking blocker effects into account, is provided. Fully differential Op-Amp with Miller feedback and feed-forward compensations is proposed to support wideband analog circuits with low power consumption. The stability and isolation of inverter-based trans-conductance amplifier are analyzed in details. The design approach of high linearity Tow-Thomas trans-impedance amplifier is presented to reject out-of-band blockers. To compensate for PVT variations, IIP2, frequency tuning, DC offset and IQ calibration are also integrated on-chip. The SDR receiver has been implemented in 65 nm CMOS, with 1.2/2.5 V power supply and a core chip area of 2.4 mm 2 . The receiver achieves S11 input matching below −10 dB and a NF of 3–8 dB across the 0.1–4 GHz range, and a maximum gain of 82–92 dB with a 70 dB dynamic range. Dissipated power spans from 30 to 90 mW across this entire frequency range. For LTE application with 20 MHz signal bandwidth and a LO frequency of 2.3 GHz, the receiver consumes 21 mA current.

High isolation wideband CMOS T/R switch with leakage cancellation technique for software-defined radio transceiver

A 0.5–30ghz Wideband Differential CMOS T/R Switch with Independent Bias and Leakage Cancellation Techniques

High-Isolation CMOS T/R Switch Design Using a Two-Stage Equivalent Transmission Line Structure

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A Non-Reflective T/R Switch with Leakage Cancellation Technique for 5G Mmwave Application

A CMOS SPDT RF Switch with 68 Db Isolation and 1.0 Db Loss Feathering Switched Resonance Network for MIMO Applications

Differential Low‐loss T/R Switch for Phase Array Application in 0.18‐μm CMOS Technology

A 68-Db Isolation 1.0-Db Loss Compact CMOS SPDT RF Switch Utilizing Switched Resonance Network

A CMOS Dual Band Low-Loss High-Isolation Switch for 5G New Radio.

Isolation Enhancement Based On Adaptive Leakage Cancellation

An On-Chip Configurable Receiver with >55-Db Tx Leakage Suppression for UHF RFID Reader

A 0.1–4 GHz SDR receiver with reconfigurable 10–100 MHz signal bandwidth in 65 nm CMOS

Ultra Low Loss and High Linearity RF Switch Using 130nm SOI CMOS Process

A DC-10GHz SPDT RF Switch with Bulk Self-Biasing Technique in 0.25µm BiCMOS Process

A DC-50 GHz SPDT Switch with 1.5-dB Insertion Loss and 35-dB Isolation in 65-nm CMOS

The Design of a 57-65Ghz SPDT Switch with LC Resonant Techniques in 40 Nm CMOS Process

High TX-to-RX Isolation in UHF RFID Using Narrowband Leaking Carrier Canceller

An LP/CBP reconfigurable analog baseband circuit for software-defined radio receivers in 65 nm CMOS.

X‐band high isolation single pole double throw switch based on resonant concept

Co-Design of 60-Ghz Wideband Front-End IC with On-Chip T/R Switch Based on Passive Macro-Modeling

A 1.2V 0.1&#x2013;3ghz Software-Defined Radio Receiver Front-End in 130nm CMOS