Abstract:We demonstrate a direct capillary-driven method based on wetting and evaporation of various suspensions to fabricate regular two-dimensional wires in an open microfluidic channel through continuous deposition of micro- or nanoparticles under evaporative lithography, akin to the coffee-ring effect. The suspension is gently placed in a loading reservoir connected to the main open microchannel groove on a PDMS substrate. Hydrophilic conditions ensure rapid spreading of the suspension from the loading reservoir to fill the entire channel length. Evaporation during the spreading and after the channel is full increases the particle concentration toward the end of the channel. This evaporation-induced convective transport brings particles from the loading reservoir toward the channel end where this flow deposits a continuous multilayered particle structure. The particle deposition front propagates backward over the entire channel length. The final dry deposit of the particles is thereby much thicker than the initial volume fraction of the suspension. The deposition depth is characterized using a 3D imaging profiler, whereas the deposition topography is revealed using a scanning electron microscope. The patterning technology described here is robust and passive and hence operates without an external field. This work may well become a launching pad to construct low-cost and large-scale thin optoelectronic films with variable thicknesses and interspacing distances.

Microfluidic Channel Fabrication in Dry Film Resist for Droplet Generation

Fabrication of Microfluidic Devices for Droplet Generation based on Dry Film Resist

Application of Dry Film Resist in the Fabrication of Microfluidic Chips for Droplet Generation

Rapid Prototyping of Microfluidic Chips for Use in Droplet Formation and In-Vitro Compartmentalisation

Rapid Prototyping of Soft Lithography Masters for Microfluidic Devices Using Dry Film Photoresist in a Non-Cleanroom Setting

Fabrication of Glass-Based Microfluidic Devices with Dry Film Photoresists As Pattern Transfer Masks for Wet Etching

Design and fabrication of microfluidic channel using dry film photoresist for air sampling application

Micro Etching Method Inside Microchannels

Synthesis of scalable microdroplets with fluid instability of shearing flow in microfluidics

DIRECT AND ALL-DRY FABRICATION OF PAPER-BASED MICROFLUIDIC DEVICE USING PARYLENE-C DEPOSITION AND MASKLESS MICROPLASMA WRITING

Fabrication of Perfluoropolyether Microfluidic Devices Using Laser Engraving for Uniform Droplet Production

Evaporative Lithography in Open Microfluidic Channel Networks.

Droplet Pattern Formation and Translation in New Microfluidic Flow-Focusing Devices

Liquid Droplet As Efficient Master in Thin Membrane Fabrication of Poly(dimethylsiloxane) Microfluidic Devices

A Low-Cost Fabrication System for Manufacturing Soft-Lithography Microfluidic Master Molds

Microfluidics Platform for Glass Capillaries and Its Application in Droplet and Nanoparticle Fabrication.

Janus Flexible Device with Microcone Channels for Sampling and Analysis of Biological Microfluidics

Investigation of the maskless lithography technique for the rapid and cost-effective prototyping of microfluidic devices in laboratories

Easy Generation of Droplets in a Capillary Inserted Microchannel

An Integrated Microfluidic Device for Droplet Manipulation

Fabrication of a Three-Layer PDMS Pneumatic Microfluidic Chip for Micro Liquid Sample Operation