Abstract:The influence of welding velocity on the impact behavior of the globular metal transfer was studied by high speed video photography with a laser source during gas metal arc welding of E36 steel. The welding current and voltage were 180 A and 30 V during the welding process. The results indicated that the impact location of a droplet depended strongly on the welding velocity. There was a critical welding velocity (0.4 m/min) that when the welding velocity was lower than this value the droplet impacted inside the weld pool, while the welding velocity was higher than this value the droplet impacted outside the weld pool. The results showed that when a droplet impacted outside the weld pool it would rebound or adhere on the workpiece, which was depended on the kinetic energy of the droplet. The rebound percentage of droplets increased with increasing kinetic energy. With increasing welding velocity, the mass of droplets was not changed obviously, but the flight velocity of the droplet increased, i.e. the kinetic energy of droplets increased with increasing welding velocity. The results also showed that when a droplet impacted outside the weld pool, the droplet which rebounded away from the workpiece surface formed weld spatters, resulting in discontinuous weld appearance, while the droplet which adhered on the workpiece surface streamed to the weld pool and good weld joint would still be obtained. Molten metal decreases with increasing welding velocity. When the welding velocity increases from 0.4 m/min to 2.0 m/min, the weld width decreases from 12.9 mm to 6.3 mm and the weld penetration decreases from 5.4 mm to 2.1 mm. © 2012 Elsevier B.V. All rights reserved.

Effects of Welding Positions on Droplet Transfer in CO2 Laser–mag Hybrid Welding

Influence of Laser on the Droplet Behavior in Short-Circuiting, Globular, and Spray Modes of Hybrid Fiber Laser-Mig Welding

Influence of Distance Between Laser and MIG Arc on Drop Transfer Process of CO_2 Laser-Mig Hybrid Welding

Droplet transfer characteristics in high-power laser–MAG hybrid welding: Influence of energy parameters

Characteristics of Droplet Transfer in CO2 Laser-Mig Hybrid Welding with Short-Circuiting Mode

Behavior of the Plasma Characteristic and Droplet Transfer in CO2 Laser–gmaw-P Hybrid Welding

Droplet Transfer Induced Keyhole Fluctuation and Its Influence Regulation on Porosity Rate during Hybrid Laser Arc Welding of Aluminum Alloys

Effects of welding velocity on the impact behavior of droplets in gas metal arc welding

Study on droplet transfer mechanical behavior in laser-MIG hybrid welding process

Behavior and Stability of Droplet Transfer under Laser-Mig Hybrid Welding with Synchronized Pulse Modulations

Droplet detachment and motion behaviors in laser-MIG hybrid welding of aluminum alloy

Investigation on droplet transfer behavior during fiber laser-flux cored arc hybrid welding

Influence of the Laser Thermal Effect on the Droplet Transfer Behavior in Laser-Cmt Welding

New Insights into the Role of Laser Power in the Droplet Transfer of Laser-Mig Hybrid Welding

Analysis of Droplet Transfer and Porosity Characteristics in Laser-MAG Hybrid Welding of Edge Joint

Droplet Transfer and Weld Geometry in Laser Welding with Filling Wire

Effect of energy parameters on droplet transfer behavior and weld formation in laser-arc hybrid welding with cable-type welding wire

Effect of Wavelength on Droplet Transition Behaviors in Laser-CMT Hybrid Welding Process

Effect of droplet transition on the dynamic behavior of the keyhole during 6061 aluminum alloy laser-MIG hybrid welding

Mechanism investigation for the influence of laser power on droplet transfer behaviors in laser-MIG hybrid welding

Effects of Coupling Between the Laser Plasma and Two Arcs on Metal Transfer in CO2 Laser Double-Wire MIG Hybrid Welding