Catalytic properties of CuO/Sn 0.9 Ti 0.1 O 2 and CuO/Sn 0.7 Ti 0.3 O 2 in NO+CO reaction

Xiao-yuan Jiang,Feng Du,Xu Zhang,Yan-rong Jia,Xiao-ming Zheng
DOI: https://doi.org/10.1631/jzus.2007.A1839
2007-01-01
Abstract:Using Sn x Ti 1− x O 2 as carriers, CuO/Sn 0.9 Ti 0.1 O 2 and CuO/Sn 0.7 Ti 0.3 O 2 catalysts with different loading amounts of copper oxide (CuO) were prepared by an impregnation method. The catalytic properties of CuO/Sn 0.9 Ti 0.1 O 2 and CuO/Sn 0.7 Ti 0.3 O 2 were examined using a microreactor-gas chromatography (GC) NO+CO reaction system and the methods of BET (Brunauer-Emmett-Teller), TG-DTA (themogravimetric and differential thermal analysis), X-ray diffraction (XRD) and H 2 -temperature programmed reduction (TPR). The results showed that NO conversions of Sn 0.9 Ti 0.1 O 2 and Sn 0.7 Ti 0.3 O 2 were 47.2% and 43.6% respectively, which increased to 95.3% and 90.9% at 6 wt% CuO loading. However, further increase in CuO loading caused a decrease in the catalytic activity. The nitrogen adsorption-desorption isotherm and pore-size distribution curve of Sn 0.9 Ti 0.1 O 2 and Sn 0.7 Ti 0.3 O 2 represented type IV of the BDDT (Brunauer, Deming, Deming and Teller) system and a typical mesoporous sample. There were two CuO diffraction peaks (2 ϑ 35.5° and 38.7°), and the diffraction peak areas increased with increasing CuO loading. TPR analysis also detected three peaks (α, β and γ) from the CuO-loaded catalysts, suggesting that the α peak was the reduction of the highly dispersed copper oxide, the β peak was the reduction of the isolated copper oxide, and the γ peak was the reduction of crystal phase copper oxide. In addition, a fourth peak (δ) of the catalysts meant that the Sn x Ti 1− x O 2 mixed oxides could be reductive.
What problem does this paper attempt to address?