Preparation and Characterization of Ce 0.3 Ti 0.7 O 2 and Supported CuO Catalysts for NO+CO Reaction

Xiaoyuan Jiang,Liping Lou,Yingxu Chen,Xiaoming Zheng
DOI: https://doi.org/10.1023/B:CATL.0000019330.20466.87
IF: 2.936
2004-01-01
Catalysis Letters
Abstract:The Ce x Ti 1− x O 2 mixed oxides at different mole ratios ( x =0.1–1.0) were prepared by co-precipitation of TiCl 4 and Ce(NO 3 ) 3 . The structural and reductive properties of the Ce x Ti 1− x O 2 were affected by calcination temperature. At x =0.1–0.3, CeTi 2 O 6 phase was formed and mainly as amorphous after calcination at 650°C. At x =0.3, only CeTi 2 O 6 was formed after calcination at 750°C and CeTi 2 O 6 crystallized completely after calcination at 800°C. TPR analyses showed that the amount of H 2 consumption by Ce x Ti 1−x O 2 (650°C) (except x =0.1) was greater than that by single CeO 2 , and the valence of CeO 2 was the lowest (+3.18) at x =0.3. CuO/Ce 0.3 Ti 0.7 O 2 was prepared by the impregnation method and catalytic properties were examined by means of a GC micro-reactor NO+CO reaction system, BET, TPR, XRD, XPS and NO-TPD. It was found that CuO/Ce 0.3 Ti 0.7 O 2 calcined at 650°C had the highest activity in NO+CO reaction with 100% NO conversion at reaction temperature of 300°C, and at 650°C Ce 0.3 Ti 0.7 O 2 just began to crystallize. The catalytic activities were largely affected by the pre-treatment conditions. At low reduction temperature (100°C), CuO species was difficult to reduce. When high degree of reductions took place, both CuO species and Ce 0.3 Ti 0.7 O 2 reduced and thus a part of CuO species on the support surface would be covered. The XPS and NO-TPD analyses showed that CuO/Ce 0.3 Ti 0.7 O 2 had four NO absorption centers (Cu + , Cu 2+ (I), Cu 2+ (II) and Ce 3+ ). The CuO species involving in NO+CO reaction included Cu 2+ (I) and Cu + , and CeO 2 species (Ce 3+ and Ce 4+ ).
What problem does this paper attempt to address?