Abstract:TiO2/SBA-15 catalysts, TiO2 nanoparticles well dispersed on SBA-15 supporter, have been successfully obtained through a self-assembly aging, carboxylation and subsequent solvothermal process. Firstly, P123 (PEG-PPG-PEG), KCl, (2-cyanoethyl) triethoxysilane (CETES) and tetraethoxysilane (TEOS) were employed to form cyano-modified SBA-15 (CN/SBA-15) in 2.0 mol/L HCl solution by Self-assembly aging method. Secondly, carboxyl-modified SBA-15 (COOH/SBA-15) was got through carboxylation treatment in 48% H2SO4 solution at 95 degrees C for 24 h. Finally, highly dispersed TiO2/SBA-15 catalysts were successfully synthesized via solvothermal method at 220 degrees C for 12 h using COOH/SBA-15 and tetrabutyl titanate (TB) as raw materials. In order to remove the organic compounds and improve the crystallization of TiO2, the obtained TiO2/SBA-15 catalysts then were filtrated, washed by absolute ethanol for three times, dried at 80 degrees C and calcined at 550 degrees C for 4 h. Notably, the self-assembly and carboxylation process produced large number of good dispersive carboxyl groups (COOH) on SBA-15, which could effectively anchored TB molecules on SBA-15 to promise the highly dispersion of TiO2 on SBA-15. The obtained TiO2/SBA-15 catalysts have been characterized by X-ray diffraction (XRD), Raman spectrum, Fourier transform infrared spectroscopy (FT-IR), transmission electron microscopy (TEM), nitrogen adsorption and UV-Visible diffuse reflectance spectroscopy (UV-Vis). Above results indicate that the TiO2/SBA-15 catalysts exhibit large specific surface area and TiO2 on SBA-15 supporter is anatase phase, they are both play important roles in photocatalytic application. In the current manuscript, the photocatalytic reduction of CO2 under UV light irradiation as a prober reaction was used to investigate the photocatalytic performance of TiO2/SBA-15 catalysts. It was found that the obtained catalysts performed high photocatalytic capacity for CO2 reduction, especially when the loading amount of TiO2 was around 16.5 wt% [n(COOH)/n(TB)=3], the methanol production got maximum which could reach 80 mu mol/g-catalyst after 6 h UV light irradiation. Compared with the catalysts which synthesized through simple impregnation method, our TiO2/SBA-15 catalysts showed the higher activity in photocatalytic reduction of CO2, owing to the better dispersion and crystallization.

Controllable Synthesis of SrCO 3 with Different Morphologies and Their Co-Catalytic Activities for Photocatalytic Oxidation of Hydrocarbon Gases over TiO 2

Self-assembly of a Highly Stable and Active Co3O4/H-TiO2 Bulk Heterojunction with High-Energy Interfacial Structures for Low Temperature CO Catalytic Oxidation

Construction of Visible-Light-Responsive SrTiO3 with Enhanced CO2 Adsorption Ability: Highly Efficient Photocatalysts for Artifical Photosynthesis

Tailoring the oxidation state of metallic TiO through Ti3+/Ti2+ regulation for photocatalytic conversion of CO2 to C2H6

Deep Insight into the Mechanism of Catalytic Combustion of CO and CH 4 over SrTi 1– x B x O 3 (B = Co, Fe, Mn, Ni, and Cu) Perovskite via Flame Spray Pyrolysis

Co(1-nSr)TiO3 (n=0, 0.05, 0.1) nano perovskites: Novel photocatalysts synthesized by sol-gel and cold-evaporated sol-gel methods for CO remediation from polluted air

Synergetic modulation of surface alkali and oxygen vacancy over SrTiO 3 for the CO 2 photodissociation

Synthesis of Supported TiO2/SBA-15 Catalysts and Their Performance on Photocatalytic Reduction of CO2

Tailoring CuO-CeO2 active sites on strontium titanate/ultra-stable Y zeolite catalyst for photothermal catalytic oxidation of toluene

Synthesis of Bionic-Macro/microporous MgO-modified TiO2 for Enhanced CO2 Photoreduction into Hydrocarbon Fuels

Improved Charge Separation and Surface Activation Via Boron-Doped Layered Polyhedron SrTiO3 for Co-Catalyst Free Photocatalytic CO2 Conversion

Co-embedding oxygen vacancy and copper particles into titanium-based oxides (TiO2, BaTiO3, and SrTiO3) nanoassembly for enhanced CO2 photoreduction through surface/interface synergy

Synergistic Effect of Cu2+ and Cu+ in SrTiO3 Nanofibers Promotes the Photocatalytic Reduction of CO2 to Methanol

Synthesis of Nano-Sized SrTiO3 Photocatalyst by Sol-Gel Method

Manipulating morphology and surface engineering of spinel cobalt oxides to attain high catalytic performance for propane oxidation

Exceptional Co-Catalyst Free Photocatalytic Activities of B and Fe Co-Doped SrTiO3 for CO2 Conversion and H2 Evolution

In Situ ESR and TPSR Measurements of SrTi0.975Li0.025O3-δ Nanocatalysts for Oxidative Coupling of Methane at Low Temperature

Characterization of Nanosized SrTiO_3 Catalyst for Oxidative Coupling of Methane by in Situ ESR and TPSR

Single‐Atom Titanium on Mesoporous Nitrogen, Oxygen‐Doped Carbon for Efficient Photo‐thermal Catalytic CO2 Cycloaddition by a Radical Mechanism

Catalysts Based on Strontium Titanate Doped with Ni/Co/Cu for Dry Reforming of Methane

Design of SrTiO 3 -based catalysts for photocatalytic CO 2 reduction