Characterization of Nanosized SrTiO3 Catalyst for Oxidative Coupling of Methane by in Situ ESR and TPSR

Miao Jianwen

DOI: https://doi.org/10.3321/j.issn:0253-9837.2008.12.017

2008-01-01

CHINESE JOURNAL OF CATALYSIS (CHINESE VERSION)

Abstract:The perovskite-type nanosized SrTiO3 catalyst was prepared by the sol-gel method. Its structure was characterized by X-ray diffraction, transmission electron microscopy, in situ electron spin resonance, and temperature-programmed surface reaction techniques, and its catalyst performance for oxidative coupling of methane (OCM) was measured in a microreactor. The nanosized SrTiO3 catalyst exhibited better catalytic performance for OCM reaction at low temperature (-650 degrees C) than the conventional SrTiO3 catalyst with the same composition. The catalytic performance of the nanosized SrTiO3 catalyst was improved with the increase of Sr/Ti atomic ratios. Both the surface adsorption oxygen species and F centers of the perovskite-type complex oxide could activate CH4 and form C-2 hydrocarbons. However, the oxygen species on the catalyst surface eventually resulted in the complete oxidation of the reaction intermediates and C-2 hydrocarbons. In contrast, the F centers could activate CH4 at lower temperature and led to formation of C-2 hydrocarbons with higher selectivity. The better catalytic performance of the nanosized SrTiO3 catalyst was correlated to the higher concentration of F centers owing to low coordination numbers on the nanosized oxide particles.