Abstract:This paper presents a novel charge pump scheme that combines the advantages of Fibonacci and Dickson charge pumps to obtain 30 V voltage for display driver integrated circuit application. This design only requires four external capacitors, which is suitable for a small-package application, such as smart card displays. High-amplitude (<6.6 V) clocks are produced to enhance the gate drive of a Dickson charge pump and improve the system’s current drivability by using a voltage-doubler charge pump with a pulse skip regulator. This regulation engages many middle-voltage devices, and approximately 30% of chip size is saved. Further optimization of flying capacitors tends to decrease the total chip size by 2.1%. A precise and simple model for a one-stage Fibonacci charge pump with current load is also proposed for further efficiency optimization. In a practical design, its voltage error is within 0.12% for 1 mA of current load, and it maintains a 2.83% error even for 10 mA of current load. This charge pump is fabricated through a 0.11 μm 1.5 V/6 V/32 V process, and two regulators, namely, a pulse skip one and a linear one, are operated to maintain the output of the charge pump at 30 V. The performances of the two regulators in terms of ripple, efficiency, line regulation, and load regulation are investigated.

A High Conversion Ratio Component-Efficient Charge Pump for Display Drivers

Dickson Charge Pump with Gate Drive Enhancement and Area Saving

P‐52: A Fibonacci‐Like Charge Pump and Its Current Drive Capacity Enhancement for Display Driver ICs

High-Current Drivability Fibonacci Charge Pump with Connect-Point-Shift Enhancement

A regulated charge pump with wide current driving capability for low-voltage applications

Fully Integrated High-Voltage Level Shifts and Drivers for Buck Converters.

P-45: A Multi-Phase, High-Current-Drivability Charge Pump in Display Driver ICs

A New Hybrid Gate Drive Scheme for High Frequency Buck Voltage Regulators

A Fibonacci-like Charge Pump Cell for LCD Driver

P‐58: Efficiency Enhancement by Non‐Overlapping Time Design and Adaptive Ratio Control for Charge Pump of Display Drivers

An Efficient Nonlinear Charge Pump Cell For Lcd Driver

A 1-Mhz High-Efficiency 12-V Buck Voltage Regulator with a New Current-Source Gate Driver

High-voltage Integrated Circuit Technology for Plasma Display Panel Drivers

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

P‐33: A High Current‐Drive, Step‐Up Capacitive Power Converter for Display Driver

Charge Pump for LCD Driver Used in Cell Phone

A Step-Up Charge Pump with High Integration and Full-Coverage Voltage Conversion Ratio

A low-power regulator for display driver IC requiring a moderate current drivability

A New Charge Pump with High Voltage Gain for Low Supply Environment

An Efficient, Wide-Output, High-Voltage Charge Pump With a Stage Selection Circuit Realized in a Low-Voltage CMOS Process

A Charge Pump Circuit Design Based on A 0.35um Bcd Technology for High Voltage Driver Applications