Abstract:Energy-constrained biomedical recording systems need power-efficient data converters and good signal compression in order to meet the stringent power consumption requirements of many applications. In literature today, typically a SAR ADC in combination with digital compression is used. Recently, alternative event-driven sampling techniques have been proposed that incorporate compression in the ADC, such as level-crossing A/D conversion. This paper describes the power efficiency analysis of such level-crossing ADC (LCADC) and the traditional fixed-rate SAR ADC with simple compression. A model for the power consumption of the LCADC is derived, which is then compared to the power consumption of the SAR ADC with zero-order hold (ZOH) compression for multiple biosignals (ECG, EMG, EEG, and EAP). The LCADC is more power efficient than the SAR ADC up to a cross-over point in quantizer resolution (for example 8 bits for an EEG signal). This cross-over point decreases with the ratio of the maximum to average slope in the signal of the application. It also changes with the technology and design techniques used. The LCADC is thus suited for low to medium resolution applications. In addition, the event-driven operation of an LCADC results in fewer data to be transmitted in a system application. The event-driven LCADC without timer and with single-bit quantizer achieves a reduction in power consumption at system level of two orders of magnitude, an order of magnitude better than the SAR ADC with ZOH compression. At system level, the LCADC thus offers a big advantage over the SAR ADC.

A Low Power Level-Crossing ADC for Wearable Wireless ECG Sensors.

Event-driven Analog-to-digital Converter for Ultra Low Power Wearable Wireless Biomedical Sensors

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

A 300-mV 220-nW event-driven ADC with real-time QRS detection for wearable ECG sensors

An Ultra-Low Power Fixed-Window Level Crossing ADC for ECG Recording

Wireless Wearable ECG Sensor Design Based on Level-Crossing Sampling and Linear Interpolation.

Design of Ultra-Low-Power Electrocardiography Sensors

A 1V 5-bits Low Power Level Crossing ADC with OFF state in idle time for bio-medical applications in 0.18um CMOS

A 62.2db SNDR Event-Driven Level-Crossing ADC with SAR-Assisted Delay Compensation Loop for Time-Sparse Biomedical Signal Acquisition.

A 2.89-Μw Clockless Wireless Dry-Electrode ECG SoC for Wearable Sensors.

A 61-nW Level-Crossing ADC With Adaptive Sampling for Biomedical Applications

A Low Power Cyclic ADC Design for a Wireless Monitoring System for Orthopedic Implants

A 457 nW Near-Threshold Cognitive Multi-Functional ECG Processor for Long-Term Cardiac Monitoring

A 457-Nw Cognitive Multi-Functional ECG Processor

A Code-Recombination Algorithm-Based ADC with Feature Extraction for WBSN Applications

Power Efficiency Comparison of Event-Driven and Fixed-Rate Signal Conversion and Compression for Biomedical Applications

An ECG-on-Chip for Wearable Cardiac Monitoring Devices

A 1-to-1-khz, 4.2-to-544-nw, Multi-Level Comparator Based Level-Crossing ADC for IoT Applications.

A Low-Power SAR ADC with Capacitor-Splitting Energy-Efficient Switching Scheme for Wearable Biosensor Applications

A Low-power High-resolution Band-pass Sigma-delta ADC for Accelerometer Applications