Abstract:To support 16-QAM modulation in E-band applications, phase-locked loops (PLLs) are required to have wide a frequency tuning range from 71 to 86GHz and low phase noise of -90dBc/Hz @1MHz [1], which are still very challenging even with aggressive CMOS scaling [2]. Another issue associated with PLLs is the difficulty to integrate on-chip loop filters. Active loop filters are employed to scale down the loop filter capacitors and enable them to be fully integrated on-chip [3]. However, this method suffers from large active noise induced by the op-amp. Moreover, as the capacitance is reduced, the resistor value has to be increased to maintain the same zero frequency, leading to higher thermal noise and limiting achievable scaling factor. Another method is to integrate digital loop filters in all-digital PLLs (ADPLLs) [4]. Unfortunately, the quantization noise of digitally-controlled oscillators (DCOs) becomes a bottleneck to achieve good phase noise due to their limited frequency resolution. Furthermore, E-band DCO oscillation frequency is more sensitive to capacitor variation, making it even more difficult to achieve high frequency resolution. To address these issues, this paper proposes a 70.5-to-85.5GHz PLL with an injection-locked frequency tripler (ILFM3) and passive scaling to increase the effective capacitor for the loop filter by 100 times.

A Multi-Bit Fir Filtering Technique for Two-Point Modulators with Dedicated Digital High-Pass Modulation Path

A Hybrid Loop Two-Point Modulator Without DCO Nonlinearity Calibration by Utilizing 1 Bit High-Pass Modulation

A 2 GHz 2 Mb/s Semi-Digital $2^{+}$-Point Modulator with Separate FIR-Embedded 1-Bit DCO Modulation in 0.18 $\mu$ M CMOS

A 2 GHz 2 Mb/s Semi-Digital <formula Formulatype="inline"><tex Notation="TeX">$2^{+}$</tex></formula>-Point Modulator with Separate FIR-Embedded 1-Bit DCO Modulation in 0.18 <formula Formulatype="inline"><tex Notation="TeX">$\mu$</tex> </formula>m CMOS

A 10 Mb/s hybrid two-point modulator with front-end phase selection and dual-path DCO modulation

20-Mb/s Gfsk Modulator Based on 3.6-Ghz Hybrid Pll with 3-B Dco Nonlinearity Calibration and Independent Delay Mismatch Control

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

A Digital-Intensive F/Pll-Based Two-Point Modulator with A Constant-Gain Dco for Linear Fmcw Generation

A 1mb/s 2.86% EVM GFSK Modulator Based on ΔΣ BB-DPLL Without Background Digital Calibration

An Ultra Broadband Passive Vector Modulator Phase Shifter

Linearity Enhancement Method for a Wide-Band Digitally Controlled Oscillator

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

A 0.65V 1.2mw 2.4ghz/400mhz Dual-Mode Phase Modulator for Mobile Healthcare Applications

DCO gain calibration technique in fractional-N Δ-Σ PLL based two-point phase modulators.

DCO gain calibration technique in fractional-N Delta-Sigma PLL based two-point phase modulators

An Overview of Digital-Intensive ΔΣ Phase-Locked Loops Utilizing 1-Bit Conversion and Modulation.

A Gaussian-Filtered Fully-Balanced FSK Modulator with Integer-N PLL Based 1-Point Modulation.

25.6 A 70.5-to-85.5GHz 65nm phase-locked loop with passive scaling of loop filter

Hybrid Phase Modulators with Enhanced Linearity

A 65nm Cmos 3.6ghz Fractional-N Pll With 5(Th)-Order Delta Sigma Modulation And Weighted Fir Filtering