Abstract:This paper reports a low-power, high dynamic range second-order delta-sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF-B topology, consisting of a continuous-time first stage and a discrete-time second stage. The first stage is an OTA-based RC integrator with inherent anti-aliasing properties, while the second stage is a switched-capacitor integrator. Offset and 1/f noise in the first stage are mitigated by the chopper-stabilization technique, while those in the second stage are suppressed through the gain provided by the first stage. Furthermore, the OTA-sharing technology is utilized in the second stage to realize signal addition before quantization, reducing design complexity. The hybrid DSM prototype is fabricated with a 180-nm CMOS process and occupies an area of 0.123 mm(2). Measurement results show peak SNDR/SNR/SFDR values of 95.8, 97.1, and 102.8 dB, respectively, with a current consumption of 10.7 mu A from a 1.8-V single supply. The reported DSM achieves a 103-dB dynamic range in a 100-Hz signal bandwidth, corresponding to a Schreier figure-of-merit (FoMs) value of 170.2 dB.

A 10 Mb/s hybrid two-point modulator with front-end phase selection and dual-path DCO modulation

A 10.7-Μa 103-Db DR Hybrid Delta-Sigma Modulator for Sensing Applications

20-Mb/s Gfsk Modulator Based on 3.6-Ghz Hybrid Pll with 3-B Dco Nonlinearity Calibration and Independent Delay Mismatch Control

A 2 GHz 2 Mb/s Semi-Digital $2^{+}$-Point Modulator with Separate FIR-Embedded 1-Bit DCO Modulation in 0.18 $\mu$ M CMOS

A Hybrid Loop Two-Point Modulator Without DCO Nonlinearity Calibration by Utilizing 1 Bit High-Pass Modulation

A 2 GHz 2 Mb/s Semi-Digital <formula Formulatype="inline"><tex Notation="TeX">$2^{+}$</tex></formula>-Point Modulator with Separate FIR-Embedded 1-Bit DCO Modulation in 0.18 <formula Formulatype="inline"><tex Notation="TeX">$\mu$</tex> </formula>m CMOS

A Multi-Bit Fir Filtering Technique for Two-Point Modulators with Dedicated Digital High-Pass Modulation Path

A 1mb/s 2.86% EVM GFSK Modulator Based on ΔΣ BB-DPLL Without Background Digital Calibration

High-speed silicon modulator based on cascaded microring resonators.

Hybrid Phase Modulators with Enhanced Linearity

Design and Electro-Optical Co-Optimization of High-Speed Travelling Wave Silicon-Organic Hybrid Modulators

25Gbit/s Fully Cmos-Compatible Silicon Modulator Based on Interleaved Pn Junctions

High-speed, low-loss silicon Mach-Zehnder modulators with doping optimization.

A 2.4 GHz Two-Point Δ-Σ Modulator with Gain Calibration and AFC for WPAN/BAN Applications.

A 0.65V 1.2mw 2.4ghz/400mhz Dual-Mode Phase Modulator for Mobile Healthcare Applications

High speed silicon Mach-Zehnder modulator based on interleaved PN junctions.

An 11 Mw 79 Db DR ΔΣ Modulator for ADSL Applications

A 100Mb/s 3.5GHz Fully-Balanced BFOOK Modulator Based on Integer-N Hyrbrid PLL

A Digital-Intensive F/Pll-Based Two-Point Modulator with A Constant-Gain Dco for Linear Fmcw Generation

A 7.8 Mw 5.2% FSK Error Two-Point Modulator Without Calibration.

A 5MHz-BW, 86.1dB-SNDR 4X Time-Interleaved 2<sup>nd</sup>-Order ΔΣ Modulator with Digital Feedforward Extrapolation in 28nm CMOS